'91 Excel lost reverse |
Post Reply |
Author | |
1StopJeff
Groupie Joined: May-10-2012 Location: Granite Bay, CA Status: Offline Points: 43 |
Post Options
Thanks(0)
Posted: June-15-2012 at 4:27pm |
I was out on the lake yesterday and reverse worked fine and then it was gone. I checked the fluid level it and appeared to be almost a quart low, if that is what the full mark to the bottom of the gauge indicates. I headed back in and everything was fine in forward. Is this just fluid level? It is a Warner V-Drive.
|
|
1991 Nautique Excel
|
|
kapla
Grand Poobah Joined: March-27-2008 Location: BA, Argentina Status: Offline Points: 6148 |
Post Options
Thanks(0)
|
A quart seems to be much, try adding the fluid and see what happens. I´d say you probably overheated the tranny and warped the reverse clutch pack making them to loose the holding ability, like a worn out clutch. Rebuilt is the fix...
report back, good luck |
|
<a href="">1992 ski nautique
|
|
1StopJeff
Groupie Joined: May-10-2012 Location: Granite Bay, CA Status: Offline Points: 43 |
Post Options
Thanks(0)
|
Thanks, not what I wanted to hear. I thought I would have experienced some slipping first instead of it just working and then not. I am pretty mechanical, is the rebuild something I can do myself if it comes to that?
|
|
1991 Nautique Excel
|
|
Fl Inboards
Grand Poobah Joined: January-20-2008 Location: United States Status: Offline Points: 2068 |
Post Options
Thanks(0)
|
It Is a Borg Warner Transmission with a Walter V-drive! |
|
Hobby Boats can be expensive when the hobbyist is limited on their own skill and expertise.
1993 Shamrock "fat" 20. 2008 Nautique 196 5.0 |
|
1StopJeff
Groupie Joined: May-10-2012 Location: Granite Bay, CA Status: Offline Points: 43 |
Post Options
Thanks(0)
|
Looking at the manual it appears to be a Borg Warner Vee Drive which is both the trans and V-drive in one.
|
|
1991 Nautique Excel
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
|
Jeff,
It's sounding like you may need to send the trans to Eric/Vince at FFM For a rebuild. He uses steel clutch plates on the reverse clutch plates to overcome the common breakage issue. |
|
eric lavine
Grand Poobah Joined: August-13-2006 Location: United States Status: Offline Points: 13413 |
Post Options
Thanks(0)
|
yes, it sounds as if the plates are snapped, hard shift into reverse or a worn damper plate is many times the culprit
|
|
"the things you own will start to own you"
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |