Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - No Water strainer??  what the heck...
  FAQ FAQ  Forum Search   Register Register  Login Login

No Water strainer?? what the heck...

 Post Reply Post Reply   
Author
eshowcase View Drop Down
Newbie
Newbie
Avatar

Joined: April-15-2010
Status: Offline
Points: 36
Post Options Post Options   Thanks (0) Thanks(0)   Quote eshowcase Quote  Post ReplyReply Direct Link To This Post Topic: No Water strainer?? what the heck...
    Posted: May-02-2010 at 5:44pm

Hi folks,

I just picked up a 1992 snob, has the standard ford 351w pro-tech. Doing the standard spring tune-up work to get the boat ready... I went to clean the water strainer, this is the clear/white plastic screw on container, o-ring seal, with a metal screen strainer... good to clean out regularly. Anyway... to my surprise, there isn't one!

The water intake hose goes from the pick-up in the bottom of the boat, around the tranny and through a slender grey cylinder, then under the motor straight up front to the water pump/impeller.

Is this an issue? Should I have a strainer? Was this common in some boats?

Thanks!
Back to Top
OverMyHead View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: March-14-2008
Location: MN
Status: Offline
Points: 4861
Post Options Post Options   Thanks (0) Thanks(0)   Quote OverMyHead Quote  Post ReplyReply Direct Link To This Post Posted: May-02-2010 at 6:03pm
People argue for and against using the metal strainers on this site, but I personally am comforted seeing the clear bowl fill each time I start the boat after its been out of the water. I believe the slender grey cylinder is the tranny cooler. Someone wiser than I will give you a definitive answer.
For thousands of years men have felt the irresistible urge to go to sea, and many of them died. Things got better after they invented boats.
1987 Ski Nautique

Back to Top
Kristof View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: October-08-2007
Location: Bree, Belgium
Status: Offline
Points: 3399
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kristof Quote  Post ReplyReply Direct Link To This Post Posted: May-02-2010 at 6:42pm
Had the same discussion with a few people on this site. But, I'm with Dave on this one. Didn't have one on mine either, but I'm in for the comfort too, as stated by Dave, so I ordered one from Skidim. Love to see the clutter swirl around in that clear bowl.
The "slender grey cilinder" is indeed the tranny cooler...

- Gun control means: using BOTH hands!
- Money doesn't make one happy, but when it rains cats and dogs, it's still better to cry in a Porsche than on a bicycle...

Back to Top
eric lavine View Drop Down
Grand Poobah
Grand Poobah


Joined: August-13-2006
Location: United States
Status: Offline
Points: 13413
Post Options Post Options   Thanks (0) Thanks(0)   Quote eric lavine Quote  Post ReplyReply Direct Link To This Post Posted: May-02-2010 at 8:50pm
first stop after the strainer, the cooler, little bitty holes that couldnt pass a kidney stone
"the things you own will start to own you"
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: May-02-2010 at 8:56pm
Ian,
If you run the boat is bad water then yes. If nice water then no.


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
behindpropeller View Drop Down
Platinum Member
Platinum Member


Joined: July-31-2006
Status: Offline
Points: 1810
Post Options Post Options   Thanks (0) Thanks(0)   Quote behindpropeller Quote  Post ReplyReply Direct Link To This Post Posted: May-02-2010 at 9:00pm
www.mcmaster.com has strainers.....less expensive than skidim and made in the USA :)

Back to Top
eshowcase View Drop Down
Newbie
Newbie
Avatar

Joined: April-15-2010
Status: Offline
Points: 36
Post Options Post Options   Thanks (0) Thanks(0)   Quote eshowcase Quote  Post ReplyReply Direct Link To This Post Posted: May-03-2010 at 12:37am
Thanks everyone.
Back to Top
tullfooter View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: March-02-2007
Location: White Lake, MI
Status: Offline
Points: 2225
Post Options Post Options   Thanks (0) Thanks(0)   Quote tullfooter Quote  Post ReplyReply Direct Link To This Post Posted: May-03-2010 at 12:13pm
Welcome Ian.
I don't have a strainer on my boat, it is on my list of things to do to the boat. Make sure you check the cleanliness of the intake side of the tranny cooler. It will "strain" some materials that you want to clean out.
Did you, by chance, pick up the SNOB in Michigan? I was watching a '92 SNOB for sale in Oxford.
Steve
Play hard, life's not a trial run.
'85 BFN
'90 BFN



White Lake, Michigan

Back to Top
eshowcase View Drop Down
Newbie
Newbie
Avatar

Joined: April-15-2010
Status: Offline
Points: 36
Post Options Post Options   Thanks (0) Thanks(0)   Quote eshowcase Quote  Post ReplyReply Direct Link To This Post Posted: May-06-2010 at 9:20pm
Originally posted by tullfooter tullfooter wrote:

Welcome Ian.
I don't have a strainer on my boat, it is on my list of things to do to the boat. Make sure you check the cleanliness of the intake side of the tranny cooler. It will "strain" some materials that you want to clean out.
Did you, by chance, pick up the SNOB in Michigan? I was watching a '92 SNOB for sale in Oxford.
Steve


No, but close... I picked mine up in Wisconsin.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC