Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Transmission Leak thru shift lever input
  FAQ FAQ  Forum Search   Register Register  Login Login

Transmission Leak thru shift lever input

 Post Reply Post Reply   
Author
skfitz View Drop Down
Senior Member
Senior Member


Joined: October-15-2009
Location: Herculaneum
Status: Offline
Points: 138
Post Options Post Options   Thanks (0) Thanks(0)   Quote skfitz Quote  Post ReplyReply Direct Link To This Post Topic: Transmission Leak thru shift lever input
    Posted: October-24-2010 at 8:14pm
4804H

Sounds like the "O" ring that has failed. The O ring's factory part number is 4804H. You might get away with just replacing it (1/2 banana job),* but if it failed there is probably a reason for the failure, like pitting of the seal surfaces, etc.

* See p. 24 of this: http://www.correctcraftfan.com/Downloads/Velvet_Service_Manual.pdf
Back to Top
Tom351 View Drop Down
Groupie
Groupie
Avatar

Joined: August-23-2010
Location: Chapel Hill, NC
Status: Offline
Points: 98
Post Options Post Options   Thanks (0) Thanks(0)   Quote Tom351 Quote  Post ReplyReply Direct Link To This Post Posted: October-23-2010 at 2:57pm
The transmission on my 1986 SN (351/1:1) has a decent leak through the point where the shift lever goes into the transmission case- I have never done any transmission work so this is my question?

How easy/difficult is it to remove the shift lever shaft (or whatever it is called) and replace the seal at this location?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC