newbie needs help |
Post Reply | Page <12 |
Author | |
GlassSeeker
Grand Poobah Joined: November-26-2008 Location: Elk Grove, CA. Status: Offline Points: 2421 |
Post Options
Thanks(0)
|
what rotation is your engine?
|
|
This is the life
|
|
dconner08
Newbie Joined: July-08-2012 Location: salisbury Status: Offline Points: 37 |
Post Options
Thanks(0)
|
Not sure |
|
Bri892001
Grand Poobah Joined: September-27-2008 Location: Boston MA Status: Offline Points: 4945 |
Post Options
Thanks(0)
|
Now, does this boat lean at rest also, or only in gear?
Here's my thoughts: *The boat originally had a Right Hand (also known as Reverse) motor and a RH prop to go with it *They swapped in a new motor that was LH *Then, they swapped a LH prop to go with the new motor *The boat then started to lean to the right under power, because the boat was more designed for RH, and the torque of the LH is pushing it over to the right *They installed the tabs to try and straighten it out |
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
More than likely you have a car engine replacement. The torque of the engine you now have and your weight are pushing the boat down on the drivers side. Correct Craft originally put an opposite rotation motor,a right hand one, to counter act that force so that side would be lifted instead and ride level. I'll bet the tabs were a crude attempt to fix.
Brian you must type faster |
|
dconner08
Newbie Joined: July-08-2012 Location: salisbury Status: Offline Points: 37 |
Post Options
Thanks(0)
|
yeah it does seem to have a slight lean at rest as well but once it takes off it leans hard to the right
|
|
79 ski tique- first boat and its a learning process
|
|
Post Reply | Page <12 |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |