Raw water cooling flow diagram |
Post Reply |
Author | |
Mogens
Newbie Joined: November-02-2018 Location: Denmark Status: Offline Points: 12 |
Post Options
Thanks(0)
Posted: November-29-2018 at 2:59am |
Hi
I have a 71-72 ish correct craft conqueror crusader 302 with 220HK On the exhaust manifold there is a gasket just before the end piece where the exhaust hose is mounted. there is a stainless center in this gasket, this plate closes for water flow is it correct? Is there a good overview of water flow in a drawing or manual. ? My engine is with raw water cooling. |
|
KENO
Grand Poobah Joined: June-06-2004 Location: United States Status: Offline Points: 10646 |
Post Options
Thanks(0)
|
Hi Mogens Page 32 of the manual in the link has a block diagram of the cooling water flow for raw water cooling on a Conqueror Crusader Ford from that time period It's not exactly the simplest cooling system out there link |
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
|
Mogens, Could you post some pictures of the exhaust manifolds, the elbow (where the hose connects) and the gasket between the two. They would give us a better idea of what you have exactly. There is a possibility they have been changed/retro fitted at some point. |
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21109 |
Post Options
Thanks(0)
|
I agree, post a pic of the manifolds and that gasket. Several of us have conqueror crusaders and are familiar with the cooling system.
|
|
Mogens
Newbie Joined: November-02-2018 Location: Denmark Status: Offline Points: 12 |
Post Options
Thanks(0)
|
Hi
Here is a photo of the 302 still in the hull. Its out now and in loose parts. |
|
Mogens
Newbie Joined: November-02-2018 Location: Denmark Status: Offline Points: 12 |
Post Options
Thanks(0)
|
I have 2 solid gaskets
Its either from the from or rear. I did not see this before separating the part, if its in the front or back I cant tell. Or it's a wrong gasket . |
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21109 |
Post Options
Thanks(0)
|
I’m familiar with the manifolds and the cooling... I want to see these gaskets you’re talking about.
|
|
Mogens
Newbie Joined: November-02-2018 Location: Denmark Status: Offline Points: 12 |
Post Options
Thanks(0)
|
Hi
Here is the 2 gaskets |
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21109 |
Post Options
Thanks(0)
|
I do not recall splitting mine, but I would block the bottom. The 3-hole gasket should go on the front plate and the 1-hole should go between the manifold and riser.
Is that crusader blue? Pm me if you want decals. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |