Boats For Sale:
Transmission oil cooler mounting location |
Post Reply 
|
| Author | |
Wilhelm Hertzog 
Senior Member 
Joined: June-14-2014 Location: Cape Town Status: Offline Points: 334 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Transmission oil cooler mounting locationPosted: July-31-2021 at 12:44pm |
|
Why does the Velvet Drive installation manual state on page 18 (21 of 29 on the PDF pages) that the cooler should preferably be mounted at or below the transmission centerline, yet the stock mounting location (and every picture I've seen of a transmission oil cooler installation) appears to be above the centerline?
|
|
|
1982 Ski Nautique PCM351W RR II Velvet Drive 10-17-003 1:1 II PerfectPass Stargazer
Do not go gentle into that good night. Rage, rage against the dying of the light. |
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-31-2021 at 2:07pm |
|
I beleave that in the early days of the hydraulic marine reverse gears (transmisions) they were concerned with air entrapment in the oil circuit of the cooler. Then as the years went by, it was determined that there's enough velocity of the oil that air doesn't get traped evn if the cooler is above the centerline of the trans.
|
|
|
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 11116 |
Post Options
Thanks(0)
Quote Reply
Posted: July-31-2021 at 8:58pm |
Here's a picture of somebody's Escort in a semi original 77 Tique.  It's cooler is mounted at or near the transmission centerline at a bit of an angle. Commander and Indmar 351's had their cooler down low and horizontal and at or near the centerline of the transmission and most every Mercruiser inboard engine over the years that used a Borg Warner has the cooler down low, horizontal and at or near the centerline of the transmission. The manual you referenced gives a preferred location of horizontal and at or near the centerline which prevents drainback from the cooler. The PCM location allows for drainback after shutdown which isn't a big deal, it just complicates reading your fluid level, but it cools just fine as long as it's plumbed according to the manual. It's also pretty easy to access and it's easy to drain the water side for winterizing. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options