Boats For Sale:
Drug Running Boat - non CC |
Post Reply 
|
| Author | |
tnplicky 
Senior Member 
Joined: December-22-2006 Location: C'trl Illinois Status: Offline Points: 333 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Drug Running Boat - non CCPosted: April-28-2007 at 10:01pm |
|
In case you have some extra time on your hands and want to read a short story about a lot of outboards on a boat (from Snopes.com Urban Legand website)....
Drug Running Boat |
|
 |
|
|
nates78ski
Platinum Member 
Joined: January-24-2005 Location: United States Status: Offline Points: 1041 |
Post Options
Thanks(0)
Quote Reply
Posted: April-29-2007 at 12:12am |
|
haha my dad had a picture of this from an email he got a few weeks ago at our shop. I heard they couldnt catch it for a while & actually managed to figure out where it was going(probably the chopper they talked about) & busted em then... AWESOME!!! I could totally barefoot behind that!!
Nate |
|
|
|
|
79nautique
Grand Poobah 
Joined: January-27-2004 Location: United States Status: Offline Points: 7872 |
Post Options
Thanks(0)
Quote Reply
Posted: April-29-2007 at 1:28am |
|
stupid, photo shop sh*t. lets raise the outside motor's so they spin in the air on plane that's fast right?
|
|
|
|
|
Tim D
Grand Poobah
Joined: August-23-2004 Location: United States Status: Offline Points: 2635 |
Post Options
Thanks(0)
Quote Reply
Posted: April-29-2007 at 9:10am |
|
How many gallons of gas does it need to carry?
|
|
|
Tim D
|
|
|
|
|
reidp
Platinum Member
Joined: December-06-2003 Location: Mooresville, NC Status: Offline Points: 1804 |
Post Options
Thanks(0)
Quote Reply
Posted: April-29-2007 at 9:46am |
|
Chris,
I don't think that's photoshopped, and if so they did a good job with the shadows on the water. The hard-bottom hull is a vee and needed those outside engines raised. The link shows the first shots I've seen of it actually out of the water. |
|
|
|
|
Randy_in_Ohio
Platinum Member
Joined: September-13-2006 Location: N. Canton, OH. Status: Offline Points: 1891 |
Post Options
Thanks(0)
Quote Reply
Posted: April-29-2007 at 9:47am |
|
79 , This was confirmed true by snopes.com. if you look at the bottom of the page they site their sources. you could check them out yourself if you wanted to.
I thought the side motors were mounted higher on the sides at first look too. if you look a little closer, the motors on the ends are larger, but the props are all a the same level. |
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040 |
Post Options
Thanks(0)
Quote Reply
Posted: April-30-2007 at 6:25am |
|
Tim, 3400 gallons! I'd like to see the instrument panel!
|
|
|
|
|
fixitjim
Newbie 
Joined: May-04-2006 Location: United States Status: Offline Points: 27 |
Post Options
Thanks(0)
Quote Reply
Posted: April-30-2007 at 9:26am |
|
Actually, it looks like all the motors are the same size (250) and height. The hull looks to have a step down from outside to the center so the motors can be higher on the outsides and still mounted to the transom (which I'm sure is very strong).
|
|
|
fixitjim
|
|
|
|
|
JoeinNY
Grand Poobah
Joined: October-19-2005 Location: United States Status: Offline Points: 5693 |
Post Options
Thanks(0)
Quote Reply
Posted: April-30-2007 at 10:40am |
|
The ones in the middle are definitely too low, way to much rooster tail. Someone who knew what they were doing with some jack plates, lower unit work, and surface piercing props should have been able to get it to go faster without the 4 motors on the ends.
|
|
|
|
|
75 Tique
Grand Poobah
Joined: August-12-2004 Location: Seven Lakes, NC Status: Offline Points: 6100 |
Post Options
Thanks(0)
Quote Reply
Posted: May-02-2007 at 8:46am |
|
Ran across this on Freerepublic this morning.
|
|
|
_____________
“So, how was your weekend?” “Well, let me see…sun burn, stiff neck, screwed up back, assorted aches and pains….yup, my weekend was great, thanks for asking.” |
|
|
|
|
Messer
Groupie 
Joined: May-28-2007 Location: United States Status: Offline Points: 63 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2007 at 11:26pm |
|
From personal involvement- that's no photo shop job, she's the real deal.
|
|
|
Johnnie
1987 Ski Nautique 1981 Fish Nautique 1980 Fish Nautique 1979 Fish Nautique 1986 Master Craft 1984 American Skier |
|
|
|
|
behindpropeller
Platinum Member
Joined: July-31-2006 Status: Offline Points: 1810 |
Post Options
Thanks(0)
Quote Reply
Posted: June-05-2007 at 2:25pm |
|
twin rig hydrodynes have the outside motors raised up just a hair too.
|
|
|
|
|
Nautique2001
Grand Poobah
Joined: June-14-2004 Location: Massachusetts Status: Offline Points: 2832 |
Post Options
Thanks(0)
Quote Reply
Posted: June-06-2007 at 1:06pm |
|
They need a Yamaha mechanic on retainer, dang.
Ken |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options