rear motor mounts

"I replaced those isolators recently but they were off and on the work bench. I used a deep socket that would slide over the stud and inside the mount and "bumped" them in with a rubber mallet, then replaced the washer and clip. You say the snap ring is there but what about the washer? It should be between the isolator and the snap ring."

this is bob's2001 post from early last year...does anyone know the o/d of this washer or have a pic?

neither of my mounts had this washer under the spring clip; I did see on the much referred to thread on alignment, a very good pic...but it looks like mine w/o the washer referred to by the post above

any help appreciated and I'll get my club dues out tomorrow