1988 Nautique Dash Panel.

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   I have a half dozen water jet cut 1988 Ski Nautique switch panels. I had these cut from aluminum.  They will need fine tuning, painting and screen printed.  With this the broken center piece will be permanently eliminated.  

$55 including shipping.   

Richard Grimes. 205-229-5534

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
rgrimes007 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: September-03-2014 Location: Hoover, AL Status: Offline Points: 31	Post Options Post Reply Quote rgrimes007 Report Post Thanks(0) Quote Reply Topic: 1988 Nautique Dash Panel. Posted: October-15-2017 at 2:01pm
	I have a half dozen water jet cut 1988 Ski Nautique switch panels. I had these cut from aluminum. They will need fine tuning, painting and screen printed. With this the broken center piece will be permanently eliminated. $55 including shipping. Richard Grimes. 205-229-5534
	Richard Grimes

8122pbrainard Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41040	Post Options Post Reply Quote 8122pbrainard Report Post Thanks(0) Quote Reply Posted: October-15-2017 at 2:32pm
	Richard, I'm curious how you finished yours. You mention screen printing. Did you have a screen made for the graphics? How about some pictures?
	54 Atom 77 Tique 64 X55 Dunphy Keep it original, Pete <

TRBenj Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21107	Post Options Post Reply Quote TRBenj Report Post Thanks(0) Quote Reply Posted: October-15-2017 at 7:55pm
	I'd like to see the finished product as well... pics?

rgrimes007 Members Profile Send Private Message Find Members Posts Add to Buddy List Newbie Joined: September-03-2014 Location: Hoover, AL Status: Offline Points: 31	Post Options Post Reply Quote rgrimes007 Report Post Thanks(0) Quote Reply Posted: October-15-2017 at 8:01pm
	I have done them a couple of different ways but have sold the boats that I used the in. The best look I came up with was black anodized with screen printed switch lables.... I do not have pictures or the screen. These are just raw aluminum. You would need to wet sand the face taking note to get the sanding marks all in line. ( about 320 grit) and have it anodized. I have also powder coated one and it looked good. Not as good as anodizing but was much less involved. Email me. I cannot figure out how to post a picture to the forum on my iPad. Rgrimes@RealtySouth.com
	Richard Grimes

1988 Nautique Dash Panel.

About CCF

Donate

Partners

Contact