trailer swap?
Printed From: CorrectCraftFan.com
Category: General Correct Craft Discussion
Forum Name: General Discussion
Forum Discription: Anything Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=42811
Printed Date: April-28-2024 at 10:30pm
Topic: trailer swap?
Posted By: JWB
Subject: trailer swap?
Date Posted: May-20-2018 at 2:40pm
I have a 1990 Sport
I would like to adapt a 1988 Correct Craft trailer from a 1988 Barefoot
Looks to be doable,
anyone ever adapt one before?
cant post pics
thanks
|
Replies:
Posted By: gt40KS
Date Posted: May-20-2018 at 6:02pm
The only thing that immediately jumps out for me is hull size difference between the 90's and the 80's Nautiques. Width may be a problem depending on whether the hull sits above or below the wheel wells and exactly how snug of fit it is. On my Ramlin trailer with my 95, the hull sits about 3 inches lower than the wheel wells and is only about 3 inches narrower than the width between them. I'm thinking the 88's were 5" or 6" narrower beam than your sport?? Also, if it is a single axle their may be issues with the weight distribution front to back considering your Sport is a foot or so longer.
Lots of folks with more CC experience here that will no doubt clarify or correct me later, but there is a start for you .
-------------
JCCI
1995 Ski Nautique GT40
|
Posted By: JWB
Date Posted: May-20-2018 at 8:54pm
Width can be overcome by going over the fenders length cannot .Boat cannot be put far enough on the trailer to balance out right.Anyone need a Barefoot CC trailer 1988 ???
I need a Sport trailer 1990 🙄🙄🙄🙄
thanks
|
|