Windshield screws
Printed From: CorrectCraftFan.com
Category: Repairs and Maintenance
Forum Name: Boat Maintenance
Forum Discription: Discuss maintenance of your Correct Craft
URL: http://www.CorrectCraftFan.com/forum/forum_posts.asp?TID=48972
Printed Date: April-25-2024 at 12:07pm
Topic: Windshield screws
Posted By: gun-driver
Subject: Windshield screws
Date Posted: June-29-2020 at 4:05pm
|
My passenger side windshield is loose, I’d like to tighten or replace the screws. What is the best way to remove the foam covering the channel where the screws are? I’m guessing worse case scenario I have to replace the foam stripping. I’m trying to avoid that as they changed the stripping so I would have to do both sides. |
Replies:
Posted By: TRBenj
Date Posted: June-29-2020 at 4:20pm
| Is it foam? The early 90’s version is rubber and is easily reinstalled. Just gotta get a small screwdriver under one side to get it started. |
Posted By: gun-driver
Date Posted: June-29-2020 at 5:03pm
|
Tim 2000 Sport i meant rubber but its so deteriorated on the outside it looks like foam.  I’ll give the little screwdrivers a shot was just wondering if there was a trade secret to removal. 
|
Posted By: Jonny Quest
Date Posted: June-29-2020 at 5:20pm
|
It just pulls out. If it’s too old and brittle, it won’t come out in 1 piece. ------------- Current 2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
Posted By: gun-driver
Date Posted: June-29-2020 at 6:05pm
|
Success It’s a more of a foam than a rubber sort of like a something that would be used to seal an airbox. |