Step Pads |
Post Reply ![]() |
Page <1 234 |
Author | ||
Gcraig ![]() Newbie ![]() ![]() Joined: July-28-2012 Location: United States Status: Offline Points: 2 |
![]() ![]() ![]() ![]() ![]() |
|
What value would you give to a fully restored X55 dunphy like this?
|
||
Craig
|
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Craig, Like what? No pictures? Keep in mind this is a Correct Craft site. Your post would be more appropriate if it was in the "off topic" section. As an X55 owner of over 30 years as well as being acquainted with most still around, I could help. |
||
![]() |
||
DieselCash ![]() Groupie ![]() ![]() Joined: October-30-2011 Location: Killeen, TX Status: Offline Points: 53 |
![]() ![]() ![]() ![]() ![]() |
|
were do these step pads mount at?
My boat currently does not have any. |
||
1992 Sport Nautique
|
||
![]() |
||
Gary S ![]() Grand Poobah ![]() ![]() Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
![]() ![]() ![]() ![]() ![]() |
|
Your boat is way too new for these pads,50,60,early 70's used these
|
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Come on Craig, I'm sitting on the edge of my chair waiting for the X pictures!!! ![]() ![]() |
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Craig,
Your last visit was this morning at about 7:30 so I know you have been back on the site. ![]() |
||
![]() |
||
Gary S ![]() Grand Poobah ![]() ![]() Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
![]() ![]() ![]() ![]() ![]() |
|
Here's a picture Pete,it's a little rough around the edges but it was used at WeekiWachee in the famous Mermaid ski show.A few repairs and the special Cosworth Ford engine back in and it will be good to go
![]() ![]() |
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Gary,
![]() ![]() ![]() |
||
![]() |
||
Gcraig ![]() Newbie ![]() ![]() Joined: July-28-2012 Location: United States Status: Offline Points: 2 |
![]() ![]() ![]() ![]() ![]() |
|
I have been traveling and am new to the site. I am not interested in se/ling just interested in what you think pro e range is for a fully restored 1964 X55 with new uphols
|
||
Craig
|
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Craig, Again, pictures are needed. |
||
![]() |
||
boat dr ![]() Grand Poobah ![]() ![]() Joined: June-27-2004 Location: United States Status: Offline Points: 4245 |
![]() ![]() ![]() ![]() ![]() |
|
Peter, I would venture to say "trolling not allowed" but what do I know ?
|
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Billy, I'm going to have to call you as I need a translation on this one! I'm not catching on! ![]() ![]() |
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Billy, I think you "nailed" this one! Even after several posts and PM's to Craig asking for more info, I have gotten no responces from him. Just the one here in the tread that he's been on the road? He was just on site this morning viewing his PM's so, it's my belief your idea has been confirmed! ![]() ![]() |
||
![]() |
||
8122pbrainard ![]() Grand Poobah ![]() ![]() Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
![]() ![]() ![]() ![]() ![]() |
|
Frank,
I sincerely need to apologize here for the blatant thread jack. I'm sorry but am sure our members will make it though all the BS and get back in line with your step pads. BTW, "Craig" has not responded to any of my PM's! ![]() |
||
![]() |
||
FrankT ![]() Senior Member ![]() ![]() Joined: September-07-2006 Status: Offline Points: 245 |
![]() ![]() ![]() ![]() ![]() |
|
no problem. I have been traveling and didn't even notice.
FrankT |
||
![]() |
||
JBULL124 ![]() Newbie ![]() Joined: July-30-2011 Location: California Status: Offline Points: 11 |
![]() ![]() ![]() ![]() ![]() |
|
Hi Frank
How do I go about Buying 4 of these pads from you ? My email address is Joe@JoeBullock.com I am also looking for a windshield for a 1966 Barcudda Correct Craft if you know where I can find one. |
||
"Joe" Everyday is a Holiday
|
||
![]() |
||
JBULL124 ![]() Newbie ![]() Joined: July-30-2011 Location: California Status: Offline Points: 11 |
![]() ![]() ![]() ![]() ![]() |
|
Hi Frank
I would like to buy a set of these steps. How do I pay you for them ? Thank You Joe Bullock |
||
"Joe" Everyday is a Holiday
|
||
![]() |
||
Fat Willie ![]() Newbie ![]() Joined: August-03-2015 Location: Columbus, Ga. Status: Offline Points: 6 |
![]() ![]() ![]() ![]() ![]() |
|
I am fairly new to the forum so I hope this goes to the right person. I'm restoring a 1962 Aqua Skier and need a set of four of the step pads mentioned in this thread. I would need to measure mine but the ones in the pictures look like a perfect match. Can you please advise of price and availability for a set of four white pads?
|
||
Fat Willie
|
||
![]() |
||
Gary S ![]() Grand Poobah ![]() ![]() Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
![]() ![]() ![]() ![]() ![]() |
|
Frank has not logged in for almost a year,you might want to try to email him at the email listed in the beginning of the thread-- tamanko@aol.com If you get ahold of him let the rest of us know please
|
||
![]() |
Post Reply ![]() |
Page <1 234 |
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |