Motor mount and water pump pulley

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   The rubber in the motor mounts in my 76 tique is junk and i need some new stuff. also the double groove pulley on the water pump (302) is 1/2 inch too big and causes interference with the crank pulley. I need one that is 6 inches in diameter. Thanks for looking and helping.

Ben

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
thateb Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: August-28-2012 Location: Pierre, SD Status: Offline Points: 52	Post Options Post Reply Quote thateb Report Post Thanks(0) Quote Reply Topic: Motor mount and water pump pulley Posted: September-06-2012 at 2:03pm
	The rubber in the motor mounts in my 76 tique is junk and i need some new stuff. also the double groove pulley on the water pump (302) is 1/2 inch too big and causes interference with the crank pulley. I need one that is 6 inches in diameter. Thanks for looking and helping. Ben

Got Tiques Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: February-27-2009 Location: Scotia, NY Status: Offline Points: 427	Post Options Post Reply Quote Got Tiques Report Post Thanks(0) Quote Reply Posted: September-06-2012 at 5:02pm
	Ben, I'm sure I have the pulley for a 302 that mounts on the water circulation pump that carries two v-belts. I'll measure this afternoon for 6" and email you back. Todd Benjamin
	'78 Ski Tique

thateb Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: August-28-2012 Location: Pierre, SD Status: Offline Points: 52	Post Options Post Reply Quote thateb Report Post Thanks(0) Quote Reply Posted: September-06-2012 at 5:29pm
	Awesome! You are becoming my favorite person Todd!

Got Tiques Members Profile Send Private Message Find Members Posts Add to Buddy List Senior Member Joined: February-27-2009 Location: Scotia, NY Status: Offline Points: 427	Post Options Post Reply Quote Got Tiques Report Post Thanks(0) Quote Reply Posted: September-07-2012 at 12:15am
	Ben, I measured the pulley, however it is 6-3/8", not 6" per your email on the OD of the double sheave pulley, you may want to recheck your measurement, because it mounts on the engine circulating pump and is standard for Fords. But I cant sell it yet, as I haven't found a spare in my inventory for my motor. The pulleys fit fairly close together, but you may want to check your bottom pulley size if it is hitting the upper pulley. I think they are both 6-3/8" OD. Let me know what you find. Give me a few days, and I'll get back to you on availability of my pulley. Thanks, Todd
	'78 Ski Tique

Motor mount and water pump pulley

About CCF

Donate

Partners

Contact