Boats For Sale:
Rebuilt trans - won’t shift into gear |
Post Reply 
|
| Author | |
hollywoodswole 
Newbie 
Joined: December-06-2005 Location: United States Status: Offline Points: 33 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Rebuilt trans - won’t shift into gearPosted: June-05-2006 at 5:25pm |
|
I just rebuilt and installed my Velvet Drive. After starting the engine and running it for a bit, I tried to shift it into gear, but the lever wouldn't budge. I know never to run it out of water to not burn up the bushing, but I just had to see if it would even spin before I go all the way out to the lake. It's definitely internal because the cable shifts just fine without the cotter pin holding it in. Any ideas?
|
|
 |
|
|
GottaSki
Grand Poobah 
Joined: April-21-2005 Location: NE CT Status: Offline Points: 3363 |
Post Options
Thanks(0)
Quote Reply
Posted: June-05-2006 at 5:46pm |
|
eeww, doesn't sound good. Can you move the lever when its not running?
|
|
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
|
|
|
hollywoodswole
Newbie
Joined: December-06-2005 Location: United States Status: Offline Points: 33 |
Post Options
Thanks(0)
Quote Reply
Posted: June-06-2006 at 4:11pm |
No |
|
|
|
|
jimbo
Senior Member 
Joined: September-07-2004 Location: United States Status: Offline Points: 473 |
Post Options
Thanks(0)
Quote Reply
Posted: June-06-2006 at 4:41pm |
|
Will the lever move if it's disconnected from the cable?
Did you pull the lever when you did the rebuild? I relaced the oring in that shaft not too long ago and as I recall, there's not really anything to bind it up (unless the pieces weren't put back together correctly). I think the lever just moves the shaft to allow the oil to shoot through one hole or another. |
|
|
|
|
hollywoodswole
Newbie
Joined: December-06-2005 Location: United States Status: Offline Points: 33 |
Post Options
Thanks(0)
Quote Reply
Posted: June-07-2006 at 6:07pm |
|
jimbo, you are right, there is nothing in there to bind, which is what had me confused. i just got back in town, pulled the switch and control valve, and found a broken switch cam. The tab on the end had broken off and was jamming the control valve. Any ideas what would have caused this?
The good news is that it spins freely without it. The bad news is that I'll have to wait a few days for a part. Again. |
|
|
|
|
GottaSki
Grand Poobah
Joined: April-21-2005 Location: NE CT Status: Offline Points: 3363 |
Post Options
Thanks(0)
Quote Reply
Posted: June-08-2006 at 9:32am |
|
good to hear.
|
|
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
GottaSki wrote: