Boats For Sale:
Teleflex Tachometer wires |
Post Reply 
|
| Author | |
Tomski 
Senior Member 
Joined: October-19-2006 Location: United Kingdom Status: Offline Points: 227 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Teleflex Tachometer wiresPosted: April-23-2008 at 7:52am |
|
If it goes to 6k when the starter is turning you have an issue with a short between the start and ignition circuits. The move to 200 when the ignition is on could point to the same thing.
I had a problem with the tacho on my little car, same kind of issues. I ran a jumper wire straight from the coil to by pass the signal wire in the loom and it was fine. I spoke to an instrument specialist and he suggested putting a resistor in the signal wire and that cured it straight off. |
|
|
Easily Parted From Money
|
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: April-23-2008 at 7:16am |
If the tach is set on the 8 cyl, and wired correctly then there is a internal problem. I do not know anyone who does repairs on these Teleflex tachs. If you found someone who is really into electronics and is willing to take a look at it, it would be your only choice unless someone else has a idea. |
|
|
|
|
JUST-IN-TIME
Newbie 
Joined: June-25-2007 Location: United States Status: Offline Points: 35 |
Post Options
Thanks(0)
Quote Reply
Posted: April-23-2008 at 4:13am |
|
you need to change the settings on the tach
|
|
|
www.switchbait.com
|
|
|
|
|
Sam B
Senior Member
Joined: November-17-2007 Location: StevensPoint WI Status: Offline Points: 393 |
Post Options
Thanks(0)
Quote Reply
Posted: April-22-2008 at 12:19am |
|
When you say not the right resistance is there something i can change on the tach to make it right?
Thanks Sam |
|
|
|
|
79nautique
Grand Poobah
Joined: January-27-2004 Location: United States Status: Offline Points: 7872 |
Post Options
Thanks(0)
Quote Reply
Posted: April-21-2008 at 1:05pm |
|
with the key on the tach should read 0, with it off it doesn't matter where it goes. Sounds like something is reversed or it's not the right resistance.
|
|
|
|
|
Sam B
Senior Member
Joined: November-17-2007 Location: StevensPoint WI Status: Offline Points: 393 |
Post Options
Thanks(0)
Quote Reply
Posted: April-20-2008 at 11:27am |
|
Yes I have it on 8 cyl. When I start the boat the tack gues to 6000. Also when I cycle the ignition on and off the tach moves up about 200 rpm every time.
Thanks for your help. Sam |
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: April-20-2008 at 10:39am |
|
Sam, You've got the tach correctly wired! What's not working properly? Bad readings? Do you have the number of cylinder jumper set correct?
|
|
|
|
|
Sam B
Senior Member
Joined: November-17-2007 Location: StevensPoint WI Status: Offline Points: 393 |
Post Options
Thanks(0)
Quote Reply
Posted: April-20-2008 at 1:01am |
|
I have a Teleflex tach in my 73 nautique. I am not sure the model number. But i can tell you that the face has the blue pin stripe circle. Anyway the problem is the wires are not the same colors as the tach I removed. The colors I have now are :
Red Blue Grey Black I think red is + Black - Grey coil Blue is light I tried the tach wired like this and it didnt work properly. Thanks Sam |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Sam B wrote: