Replacement dash for ’68 Mustang

FYI Marty Made made some amazing replica Dash panels for the 68-70 Models.

Here's a picture

turningpoint,

I actually created my own wiring drawings by tracing the wiring in the boat, one wire at a time, and drawing them out. There are some good resources on this site. Look in the manuals section. One thing I have discovered is that the factory was not consistent. For example, my 68 has a wiring harness with the colors per some manual in the resources section but the wires from the connector to the engine change colors and I could find no reference to the colors of wires on my engine. Both ends of the harness connector appear to be factory so I have to think the inconsistency is from the factory. Who knows. I wish I could be of more help. If I thought my "chicken-scratched" drawings were readable and would help you I would post them but I think they would do a lot more harm than good (and it would be a waste of time). One good thing about tracing the wiring yourself, from the dash to the engine and accessories, is that you will learn your boat. There is not that many wires and it is not as hard as it may seem. Be sure to use marine grade wire. It's important. Have fun.

Jim I'm actually about to we wire my 67 mustang, it needs a total redo, any idea where I could get a wiring diagram? I pretty much need to rewire the entire boat.

Jim_In_Houston wrote: Being the old guy I am, I have watched ammeters all of my early years and I just like them.

Jim. I'll go along with your comment! Being old and liking amp gauges!!

Nice job on the panel.

Looks great with the black on black. Are those Farina gauges? Quite a bit different from my '68 but it is an SS.I only have 3 pull switches on mine,blower,lights and bilge pump.What is your extra for?