Carb Problem |
Post Reply |
Author | |
SkiLew
Groupie Joined: May-20-2004 Location: United States Status: Offline Points: 73 |
Post Options
Thanks(0)
Posted: August-15-2005 at 8:01pm |
I removed the throttle cable when this was happening but it did not make any difference. Therefore, I am thinking that the problem must be tied to the operation of the secondary throttle shaft. |
|
Jim_In_Houston
Platinum Member Joined: September-06-2004 Location: United States Status: Offline Points: 1120 |
Post Options
Thanks(0)
|
You may want to replace your PVC valve. Maybe it is sticking partially open and falls closed after the engine is off for a period.
|
|
Happy owner of a '66 and a '68 Mustang
|
|
GottaSki
Grand Poobah Joined: April-21-2005 Location: NE CT Status: Offline Points: 3363 |
Post Options
Thanks(0)
|
The secondary throttle plates are likley hanging open a snudge.
First adjust the pivot on the throttle cable so that at idle, the cable gently pushes the throttle against the idle stop. Then, adjust the closing linkage to the secondary throttle shaft so that it forces the secondaries fully closed, and doesn't permit it hang open. You will need to adjust the bend in the rod with two pliers. If you can rotate the secondary shaft with your fingers when at idle, you can hear the rpms change, and it needs adjustment to prevent your symtoms. Another, less likely cause could be the mechanical advance getting stuck and not retarding till you shut down, pop the cap off and check for smooth operation and no broken springs; if it flops around and does not spring back, a sping is broken; if its sticky, well, it needs lube. |
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
SkiLew
Groupie Joined: May-20-2004 Location: United States Status: Offline Points: 73 |
Post Options
Thanks(0)
|
Has anyone had a problem with their engine wanting to idle too high after it has been run real hard.
I Have a 1993 351 engine with the standard Holley Carburetor. Sometimes after I have run the boat really hard the idle rpms will be so high that I am afraid to put it into gear for fear of damaging the transmission. If I shut the engine off and let it sit for just a minute or two and then restart the engine, it will usually idle normally. Again this only happens when it has been operated at nearly full throttle conditions. Any thoughts? |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |