Sale or trade trailer

lakedog55 wrote: probably, I will have to look and see, I do not have my interior all the way in so I have a bucket of parts not sure which ones are good and which ones are not. The vent at the rear should have a duct box with 2 3" circles it sort of clips in the hole and the louvered vent locks it in place, one of the connections is for the blower and the other gets a piece of hose ran that ends right at bottom stern of the boat, Mike When I get home I will sort all the parts out and will be able to let you know, I have some interior parts from my 83 somewhere as well.

Mike,

Haven't been on the site in a while but just noticed you had or have a trailer? Interested if you still have it    Thanks

probably, I will have to look and see, I do not have my interior all the way in so I have a bucket of parts not sure which ones are good and which ones are not. The vent at the rear should have a duct box with 2 3" circles it sort of clips in the hole and the louvered vent locks it in place, one of the connections is for the blower and the other gets a piece of hose ran that ends right at bottom stern of the boat,
Mike
When I get home I will sort all the parts out and will be able to let you know, I have some interior parts from my 83 somewhere as well.

Bad How are your vent boxes that connect to the vents A lot of the time they are shot too. Christines has the vents.

Sorry for the delay should be home thurs,
The vents are cracked.
The trailer is sold
Still have the spark and the cover.

Rob, did you think to measure your trailer today? No big deal if you didn't but, I was just wondering.
Do you by chance have anymore pictures of the trailer you could send to me? If so you can email them to andy_38301@yahoo.com.

Thanks,

Andy

Your 76 Southwind takes a DV 4 Correct Craft trailer and I have a good one that will be available in April for $800

Sam

Will do. I'm going back to the shop tonight and I'll measure it.

Rob

Looking for $1200, it's a really nice trailer. It has folding tongue , surge brakes and new tires.
it's made my ezloader.
Thanks

lakedog55, Do you have a stern light and the base? mslitti@comcast.net

Also lakegog55 do you have the observer seat back hinge set for an 85 nautique?

Thanks

Is that a bare hull? Was this posted on the site?

no problem I will have to pick up the carb and other stuff I will send you a pic then. still need to check out the condition of the vent and will send pics before shipping, Shipping should be around $10.00 not including the carb

Flame arrestor, $10.00
I Need to check the condition of the transom vent $5
electrical cover $5
trailer $400
just joking about the hull I will take it off

I also have a carb with fresh rebuild no gas has been in it
$125.00
or all for $500.00
Mike

How much? I need vent and cover. The used one would be fine. I also need a flame arrestor.

Thanks

Sorry I have been jumping in to some of these post. Seems easier to sell the stuff when someone wants it than posting stuff for sale.
By voltage regulator are you referring to the breaker cover on back of motor. Any way I have two your choice one original on new, vents are still on the hull. they are pretty cheap though, windshield is sold
Thanks Mike