Parts needed for a 1978 C.C. MARTINIQUE |
Post Reply |
Author | |
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21184 |
Post Options
Thanks(0)
Posted: February-07-2013 at 2:33pm |
Email sent... pretty sure you need an 11A rudder for a Martinique. 27A was used on the Mustang/Skier/Tique and had a 1" shaft instead of the 1-1/4" you probably need.
|
|
Towbosssupreme
Senior Member Joined: August-28-2009 Location: Mullins S.C. Status: Offline Points: 102 |
Post Options
Thanks(0)
|
27-A rudder , tiller arm / rudder arm for a 27-A rudder with all nuts bolts and screws , front bench seat for a pattern , rear seat top and bottom for a pattern , flat fiberglass that goes behind the rear seat ,ski pole with all hardware , 351 Commander manifolds with elbows ,raw water pump with all brackets nuts bolts and screws for a 351 Commander , wood board that screws into the rear stringers and the fuel tank sits on top of it for a pattern . This is the board that the fuel tank screws into on both sides .............. I bought a boat that had been parted out . This one needs to be put back on the water again .It is solid and original ................ All the above parts fit a 1978 Correct Craft Martinique with a 351 Commander. If you have any of the following please email me with your photos , and price shipped to ABC Discount Towing & Recovery Inc, 4737 Smithboro Loop , Mullins S.C. 29574 . abctowing29574@bellsouth.net Thanks Keith 843-464-0616
|
|
Tow Boss Supreme 71 Separator(sold) 70 Barracuda ,80 S.N ,88 Barefoot Nautique 78 American Skier 78 Martinique 77 Fish.N 67 Skylark 69 Baracuda 70 S.N. 73 Mustang,65 Century Coronado H.T 70 Century Corona
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |