Boats For Sale:
Bilge blower |
Post Reply 
|
| Author | |
gR@HaM 
Platinum Member 
Joined: May-01-2012 Location: UK Status: Offline Points: 1265 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Bilge blowerPosted: April-29-2013 at 3:52am |
|
Thanks, so just run a short section from behind the tank down to the rudder port?
Would there be any added benefit if I was to extend it to the engine compartment? If not I shouldn't have got so much house in it's the heavy duty reinforced stuff not the cheap plastic!! |
|
|
'82 Ski Tique
|
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: April-28-2013 at 7:41pm |
|
Drop a short piece of flex lower into the bilge. Gas vapors are heavier than air. It wasn't until later that they started ducting forward into the engine compartment. I still lift the dog house and take a good smell for fumes!
|
|
|
|
|
gR@HaM
Platinum Member
Joined: May-01-2012 Location: UK Status: Offline Points: 1265 |
Post Options
Thanks(0)
Quote Reply
Posted: April-28-2013 at 7:23pm |
|
Thanks Pete, will do. Tbh I'm not sure exactly where to locate the blower, behind the fuel tank?
That's where the previous one was fixed, but with no flex pipe at all so it wouldn't have been much use!!! I've since bought some 3" id tube, enough to cover the blower and also replace the 3 sections up front running from the scoop that have perished. |
|
|
'82 Ski Tique
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: April-28-2013 at 7:11pm |
|
Graham,
Besides flow in CFM, look at the specs on these flows at the given static presser (or suction). If you have lots of flex tubing, it really hurts the performance due to it being so restrictive. (air doesn't like to go past all those corrugations) |
|
|
|
|
gR@HaM
Platinum Member
Joined: May-01-2012 Location: UK Status: Offline Points: 1265 |
Post Options
Thanks(0)
Quote Reply
Posted: April-28-2013 at 6:16pm |
|
Anything I need to look out for when buying a new blower?
As I understand the higher the flow rate and the quieter the better but are there any particular make/models I should avoid? I guess Rule are a pretty good manufacturer of this kinda thing.. Thanks |
|
|
'82 Ski Tique
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options