Boats For Sale:
carb rebuild |
Post Reply 
|
| Author | |
Tim D 
Grand Poobah 
Joined: August-23-2004 Location: United States Status: Offline Points: 2641 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: carb rebuildPosted: April-24-2006 at 3:13pm |
|
They are the oldest east coast dealer.
|
|
|
Tim D
|
|
 |
|
|
skyhawkflyer
Senior Member 
Joined: February-08-2005 Location: Zimbabwe Status: Offline Points: 275 |
Post Options
Thanks(0)
Quote Reply
Posted: April-24-2006 at 11:47am |
|
www.whitelake.com
|
|
|
|
|
skyhawkflyer
Senior Member
Joined: February-08-2005 Location: Zimbabwe Status: Offline Points: 275 |
Post Options
Thanks(0)
Quote Reply
Posted: April-24-2006 at 11:29am |
|
White Lake Marina
Ph: 910-862-4013 They are the largest East Coast Correct Craft dealer. Before you go that route, you should at least pull your fuel bowls off and make sure it's not full of corrosion from water- just to make sure you have a rebuildable carb to start with. If it's corroded it's scrap. |
|
|
|
|
skyhawkflyer
Senior Member
Joined: February-08-2005 Location: Zimbabwe Status: Offline Points: 275 |
Post Options
Thanks(0)
Quote Reply
Posted: April-24-2006 at 11:22am |
|
Yes, I have stumbled on a couple of places that will exchange them but it's been a while and I can't recall where I saw the advertisements. You could do a google search, or another route would be to take it to a speed shop and get it rebuilt, most places will service Holley's. Another place to check is White Lake Marina, there are a couple of guys there that would rebuild it for you. They are in N/C.
|
|
|
|
|
floppy
Newbie 
Joined: February-01-2006 Location: United States Status: Offline Points: 31 |
Post Options
Thanks(0)
Quote Reply
Posted: April-23-2006 at 8:26pm |
|
I have a 86 nautique i believe it has a holly 4160 on it. its loading up when at a idle and peforming pretty bad out of the hole. the problem is i dont think i can rebuild one and i dont know who to trust around here. is there any where that you can exchange a carb for one already rebuilt.{like a starter at a parts house?} thanks......
|
|
|
Hey ya'll, Watch this!!!!!!!!
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options