Water pump pulley plate |
Post Reply |
Author | |
PH73
Newbie Joined: June-01-2015 Location: Madison, MS Status: Offline Points: 1 |
Post Options
Thanks(0)
Posted: June-01-2015 at 1:27pm |
I got a universal one off of ebay; I'm good to go.
Sorry I haven't answered; I've been trying to get my password reset for 2 weeks. I wasn't getting email notifications so I changed some settings on my account and reset my password. I never got an email for the reset, no matter what I did. I emailed and never got an answer from the listed emails. I've created another account and never got the activation email (not in spam either). I made a new account with my gmail address and it works. Pete, Thanks for the McMaster link, they have some cool stuff. |
|
JDD33
Senior Member Joined: October-20-2012 Location: Natick, MA Status: Offline Points: 499 |
Post Options
Thanks(0)
|
Sorry Gary, I had lousy day and just didn't expect a reasonable repair suggestion from Pete. I'll have a beer and chill for a while.
|
|
Old school goin back to school!
|
|
ncdoubleup
Senior Member Joined: August-08-2010 Location: Statesville, NC Status: Offline Points: 164 |
Post Options
Thanks(0)
|
If you can PM the diameter and hole size to me we have a CNC plasma cutter and would be happy to cut a replacement for you.
|
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
Marinetex is good but I have some tubes of sillycone left from you know where
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Gary,
I don't know about the silicone since it may not be strong enough. I would say Marinetex between the reinforcing washer and sheave would be better! |
|
Gary S
Grand Poobah Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
|
I don't think so John,I would just stack 2 or 3 washers behind each hole and use silicone to hold them in place until the bolt caught
|
|
JDD33
Senior Member Joined: October-20-2012 Location: Natick, MA Status: Offline Points: 499 |
Post Options
Thanks(0)
|
Wouldn't that qualify as redneck engineering or a back yard hack job? It wouldn't be original.....?????? Hmmmm..... Something isn't right......
|
|
Old school goin back to school!
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Paul,
Any luck yet? The plate is not a T/E exclusive so you could broaden your search. The alternate is to buy an oversize washer and drill 4 holes in it!!! Click on "flat" and then "oversize". |
|
73SN
Senior Member Joined: October-05-2005 Location: United States Status: Offline Points: 147 |
Post Options
Thanks(0)
|
I need the round plate that goes on the front of the old Thermo Electron engine water pump pulley. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |