Carb rebuild question |
Post Reply |
Author | |
shierh
Gold Member Joined: April-29-2015 Location: Florida Status: Offline Points: 605 |
Post Options
Thanks(0)
Posted: June-12-2015 at 3:31pm |
if you have the kit then use it.
the rubber parts get dry rotted and stiff, o rings that seal the cross over tube also dry out and could leak at some point. Its not a hard job so take it apart, use plenty of carb cleaner and or brake parts cleaner. and compressed air. Good to soak it since the gaskets for the metering blocks are tough to get off, carburator soak will soften them up nicely. |
|
cboland
Senior Member Joined: July-15-2004 Location: Atlanta, GA Status: Offline Points: 185 |
Post Options
Thanks(0)
|
Thanks guys. That's kinda what I was thinking too. I will pull the bowl and blow things out. Admitedly, I have not been as good as I should over the years about changing out fuel filters. That's more critical than ever these days with the crap gas otu there.
|
|
Bud
1999 Sport Nautique |
|
D&C1988
Groupie Joined: February-16-2015 Location: TableRock Lake Status: Offline Points: 67 |
Post Options
Thanks(0)
|
The only thing I can add is, DO NOT look into the carb to see if you can see anything happening when using compress air into the passages. Gas really stings in the eyes. I know from experience. Put the air gun under a old tee shirt covering the carb. Or something like that.
|
|
GottaSki
Grand Poobah Joined: April-21-2005 Location: NE CT Status: Offline Points: 3359 |
Post Options
Thanks(0)
|
Idle circuit will always be the first thing to buggar up. the clearances are such.
If you waited till the mains and PVCOs were plugged before going in, it would be tough boating. Inside the metering block is likely where your trouble lies. Fuel Filtration will need to be investigated unless you like doing rebuilds more frequently In your situaltion, One dirty trick to try before a rebuild is to remove the front bowl, inspect and clean. When off, remove the idle mix air screws. Blow compressed air in the passage where the screews go. This may dislodge debri from the idle fuel orifice. If there is crap in the bowl, address fuel filtration issue before assembling and starting. |
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
cboland
Senior Member Joined: July-15-2004 Location: Atlanta, GA Status: Offline Points: 185 |
Post Options
Thanks(0)
|
I've been fighting a rough, inconsistent idle for quite a while. I have done everything I know to dial it in including verifying timing, dwell, and using vacuum gauge to help set idle. No indication of vacuum leak either. I just can't seem to get it right and I know it's not just me being picky because I drove Timbob's 88 last weekend and it idles like a dream compared to mine.
When I turn the port side idle screw all the way in with engine running and in gear the motor stumbles but will not die. Screwing the starboard side in will quickly kill the engine. This leads me to believe the problem lies somewhere in there and something is just not right with the idle circuit. I have a carb rebuild kit, but it seems silly to use it when everything about the carb seems great except the idle. Is there something else I should investigate or is it time to just rebuild? |
|
Bud
1999 Sport Nautique |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |