Boats For Sale:
Prop nyloc nut? |
Post Reply 
|
| Author | |
8122pbrainard 
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Prop nyloc nut?Posted: June-11-2015 at 8:39pm |
Correct. I've mentioned it before that I have seen boats without nuts and the prop was still on! The nylock is fine and does add insurance. They say you are only supposed to use them once so if it goes on easy, you may want to get a new one. Yes, do lap on the new prop. |
|
 |
|
|
SNobsessed
Grand Poobah
Joined: October-21-2007 Location: IA Status: Offline Points: 7102 |
Post Options
Thanks(0)
Quote Reply
Posted: June-11-2015 at 8:32pm |
|
Lapping the prop to shaft well is the best insurance against it falling off. If the tapers match well, a puller is the only way it will come off.
|
|
|
“Beer is proof that God loves us and wants us to be happy.”
Ben Franklin |
|
|
|
|
mbshaw88
Senior Member 
Joined: April-28-2013 Location: Chicago Status: Offline Points: 244 |
Post Options
Thanks(0)
Quote Reply
Posted: June-11-2015 at 4:23pm |
|
I took the nut and prop off a while ago and there wasn't a hole in the shaft either. But after looking on the Skidim site today, they actually recommend the nyloc nut over the castle nut. So i guess I'm ok
|
|
|
|
|
Fl Inboards
Grand Poobah
Joined: January-20-2008 Location: United States Status: Offline Points: 2119 |
Post Options
Thanks(0)
Quote Reply
Posted: June-11-2015 at 4:12pm |
|
Once you pull that nut off you will probably find that the shaft is drilled and initially had a castle nut and cotter pin.. Just a observation from finding that same setup on other older Correct Crafts.
|
|
|
Hobby Boats can be expensive when the hobbyist is limited on their own skill and expertise.
1993 Shamrock "fat" 20. 2008 Nautique 196 5.0 |
|
|
|
|
mbshaw88
Senior Member
Joined: April-28-2013 Location: Chicago Status: Offline Points: 244 |
Post Options
Thanks(0)
Quote Reply
Posted: June-11-2015 at 3:38pm |
|
I'm putting on my new ACME 540 prop soon and noticed other boats have a drilled shaft. for a cotter pin. Mine is just a brass nyloc type, Is there something I can do for a fail-safe so I don't lose this new prop?
 BTW already matched the taper |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
SNobsessed wrote: