Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Help! 1976 ski tique tranny leaking
  FAQ FAQ  Forum Search   Register Register  Login Login

Help! 1976 ski tique tranny leaking
 Post Reply Post Reply   
Author
  Topic Search Topic Search  Topic Options Topic Options
DrCC View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: April-12-2004
Location: at home
Status: Offline
Points: 2867 		Post Options Post Options   Thanks (0) Thanks(0)   Quote DrCC Quote  Post ReplyReply Direct Link To This Post Topic: Help! 1976 ski tique tranny leaking
    Posted: June-19-2015 at 11:23pm
Launching I suppose would be entirely up to you. You said it runs perfect.
I never know until I take a test ride. They can sound great on a trailer, then act differently on the water. Of coarse that's engine and not necessarily trans.
We already know the trans is old, if it has sat for any length of time, it's usually the seals.
Back to Top
Bencruizen76 View Drop Down
Groupie
Groupie


Joined: May-29-2015
Location: wisconsin
Status: Offline
Points: 77 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bencruizen76 Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 11:15pm
Thank you, i had it running in the driveway today and the prop was not turning in nuetral, didnt put it in forward or reverse tho, should i for sure put it in the water before i pull the transmission out? i thank you for the help.
Back to Top
DrCC View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: April-12-2004
Location: at home
Status: Offline
Points: 2867 		Post Options Post Options   Thanks (1) Thanks(1)   Quote DrCC Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 11:06pm
Put it in the water. Take some ATF with you. If it shifts normally and does not rotate in neutral, then all you need is the front seal. And yes you can leave the bellhousing in place.
Back to Top
Bencruizen76 View Drop Down
Groupie
Groupie


Joined: May-29-2015
Location: wisconsin
Status: Offline
Points: 77 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bencruizen76 Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 10:59pm
also do i have to remove the bell housing from the motor or will the transmission come apart from the bell housing?
Back to Top
Bencruizen76 View Drop Down
Groupie
Groupie


Joined: May-29-2015
Location: wisconsin
Status: Offline
Points: 77 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bencruizen76 Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 10:44pm
nobody but was just hoping that all it would be? so it will need a rebuild for sure?
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045 		Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 9:12pm
From the other thread you posted your problem in;

Originally posted by 8122pbrainard 8122pbrainard wrote:

   
Originally posted by TRBenj TRBenj wrote:

You're correct on the seal, but it should not have any pressure behind it. Rebuild time.

I totally agree! Eric used to really comment a lot about the issue. When the pump is worn beyond tolerance, it will by pass oil and pressurize the area behind the seal. A new seal will not solve the root of the problem.

Who told you it was just a seal problem?


54 Atom

77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
Bencruizen76 View Drop Down
Groupie
Groupie


Joined: May-29-2015
Location: wisconsin
Status: Offline
Points: 77 		Post Options Post Options   Thanks (0) Thanks(0)   Quote Bencruizen76 Quote  Post ReplyReply Direct Link To This Post Posted: June-19-2015 at 7:27pm
I have a 76 ski tique with a ford 302 motor just installed, runs perfect but is leaking transmission fluid when running between bell housing and engine. The tranny is a borg warner as1-71c velvet drive with a ratio 1to1 . ive heard it could just be the front seal or does the transmission need rebuilt? I have recently aquired this boat so not sure if the tranny works or not as not had it out on the lake. Any suggestions?? your help is greatly appreciated.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

About CCF

Since 2003, CorrectCraftFan.com has been the foremost Correct Craft reference site, and simply provides the best used Correct Craft buying and selling experience anywhere.

Donate

This site is not affiliated with Correct Craft, Inc. Funding for the site comes from members like you. Click on the link below to make a donation.

Partners

Contact

Keith@CorrectCraftFan.com
Alison@CorrectCraftFan.com
www.CorrectCraftFan.com
Copyright 2024 | Bagley Productions, LLC