All of the gauges don't work |
Post Reply ![]() |
Author | |
wrollema ![]() Newbie ![]() Joined: February-12-2005 Location: Canada Status: Offline Points: 21 |
![]() ![]() ![]() ![]() ![]() Posted: July-19-2016 at 4:13pm |
Thanks, I had Nautique Service Center look at the problem and the gateway was reversed (couldn't see the fuses) all that was needed was the Gateway to be re-positioned and reset the fuse button.
|
|
![]() |
|
quinner ![]() Grand Poobah ![]() ![]() Joined: October-12-2005 Location: Unknown Status: Offline Points: 5828 |
![]() ![]() ![]() ![]() ![]() |
Check the gateway box and see of everything is plugged in and that the circuit board is not wet. Most likely the gateway is in the trunk, possibly attached to the lift ring threaded rod. If not there trace the pitot lines as they will terminate at the gateway
|
|
![]() |
|
wrollema ![]() Newbie ![]() Joined: February-12-2005 Location: Canada Status: Offline Points: 21 |
![]() ![]() ![]() ![]() ![]() |
I have 2004 Ski Nautique Limited that all of a sudden all of the sudden the gauges didn't work. I checked the Serial Bus owners manual and started checking the voltages. What I first checked are 2 voltages one is a red wire that has 12 volts always on and the other was a purple wire that has switched 12 volts where 12 volts is present once the key pad turns the engine power to on. Both of these wires terminate at the Serial Bus. I cannot locate the Serial Bus and I do not know where the Red wire originates from. Does anyone have a wiring diagram and where is the Serial Bus located?
Thanks Willy |
|
![]() |
Post Reply ![]() |
|
Tweet
|
Forum Jump | Forum Permissions ![]() You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |