Boats For Sale:
1997 PCM Apex RWP belt broke |
Post Reply 
|
| Author | |
claytc 
Newbie 
Joined: May-31-2017 Location: IL Status: Offline Points: 3 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 1997 PCM Apex RWP belt brokePosted: May-31-2017 at 6:10pm |
|
I had that initial plan to slide it over the bracket, however there is a 3rd bolt on the bottom side of the impeller housing that is almost touching the floor board where I can't slide the belt past it (and don't want to pull it across to damage the belt).
|
|
 |
|
|
Fl Inboards
Grand Poobah 
Joined: January-20-2008 Location: United States Status: Offline Points: 2119 |
Post Options
Thanks(0)
Quote Reply
Posted: May-31-2017 at 5:48pm |
|
Apex! crank driven water raw water pump? un bolt the two bolts on the pump retention bracket and slide the belt around the bracket.
|
|
|
Hobby Boats can be expensive when the hobbyist is limited on their own skill and expertise.
1993 Shamrock "fat" 20. 2008 Nautique 196 5.0 |
|
|
|
|
claytc
Newbie
Joined: May-31-2017 Location: IL Status: Offline Points: 3 |
Post Options
Thanks(0)
Quote Reply
Posted: May-31-2017 at 4:18pm |
|
Looking for any tips to replace a broken belt on a 1997 air nautique running an Apex engine without taking the full front end off. I've unbolted the impeller bracket from the block and can rotate the impeller housing some, however there is a bottom bolt on the impeller housing that is still too close to the floor board where I can slide the belt underneath. Looking for help on anyone that's done this without taking the full front housing off. I"m thinking I could remove the fuel cell and main water hose to rotate the bracket up further but was hoping others had more help to offer.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options