Boats For Sale:
Need Pics of PVC |
Post Reply 
|
| Author | |||
8122pbrainard 
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Need Pics of PVCPosted: August-19-2018 at 4:16pm |
||
John, I feel the PVC that most use is really the way to go since it provides a nice rigid and smooth inside surface. Duane used Scd, 35 (sewer and drain) that's available at any home improvement store. which is lighter weight than the typical Scd 40. If you really want to use flex, maybe finding a duct hose would be better than something designed for water and heavy for suction service. |
|||
 |
|||
|
jterr
Gold Member 
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: August-19-2018 at 3:32pm |
||
|
The long hose that you use to clean pool.
|
|||
|
|||
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: August-19-2018 at 12:41pm |
||
John, What is "swimming pool" tubing? |
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: August-19-2018 at 12:13pm |
||
|
Wonder if swimming pool tubing would work for the air ??
|
|||
|
|||
|
Snorman14
Newbie 
Joined: June-09-2018 Location: Deland Status: Offline Points: 11 |
Post Options
Thanks(0)
Quote Reply
Posted: June-10-2018 at 12:17am |
||
|
In the process of mounting it on the floor of the bow so I don’t need a special battery to fit in that floor box
|
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: June-09-2018 at 11:00pm |
||
Where did you go with the battery???? |
|||
|
|||
|
Snorman14
Newbie
Joined: June-09-2018 Location: Deland Status: Offline Points: 11 |
Post Options
Thanks(0)
Quote Reply
Posted: June-09-2018 at 9:48pm |
||
|
I just put some in a 1981 for air vent and battery cable I removed the battery box
|
|||
|
|||
|
Watauga
Senior Member 
Joined: June-12-2009 Location: United States Status: Offline Points: 208 |
Post Options
Thanks(0)
Quote Reply
Posted: June-09-2018 at 6:00pm |
||
If you decided to go that route I assume you would need to fabricate a plenum/collector of some kind that would adapt the scoop to the 6" pipe. Other issues that may make it hard to accomplish might be finding the room in the front bulkhead for the 6" pipe, and to navigate around the battery box. I believe that CC did it the way they did because of the space problem, i.e., easier to place three smaller pipes around the battery box rather one larger one. The picture above is from my boat and it took some manipulating to fit all of the elements in there. Three of the pipes are for air, one for battery cables, another for steering and control cables and the final one for the battery box drain. |
|||
|
|||
|
StuW
Newbie
Joined: January-18-2018 Location: Oswego IL Status: Offline Points: 31 |
Post Options
Thanks(0)
Quote Reply
Posted: June-09-2018 at 1:38pm |
||
|
For those of us who may not need the under bow storage, is there any reason a single, larger pvc pipe couldn't be used in place of 3 or more smaller pipes? Is there a coast guard requirement or something? My thought was to use a 6" pvc pipe straight down from the bow scoop to a 90 degree elbow and then back to the front bulkhead, no air box. Has anyone else contemplated a similar method?
|
|||
|
1982 Barefoot Nautique
PCM 454 |
|||
|
|||
|
MourningWood
Gold Member
Joined: June-13-2014 Location: NorCal Status: Offline Points: 917 |
Post Options
Thanks(0)
Quote Reply
Posted: June-05-2018 at 2:13pm |
||
|
Sounds like a great solution.
Will be doing something similar next winter during stringer job. |
|||
|
1964 Dunphy X-55 "One 'N Dun"
'I measured twice, cut three times, and it's still too short!" |
|||
|
|||
|
shierh
Gold Member
Joined: April-29-2015 Location: Florida Status: Offline Points: 605 |
Post Options
Thanks(0)
Quote Reply
Posted: June-05-2018 at 1:18pm |
||
|
I did not replace the "box"
i ran 3 3" vent hoses forward and tied off the o lifting ring mound and ran under the floor back to a forward bulkhead where i attached them to the thin wall pvc pipes that passed on each side of the battery box to a rear bulkhead. I made forward floor removable. the cables , wires, and bilge pump discharge hose are outboard side and fit through a notch in the removable deck piece. I found a heavier vent hose material than the cheep stuff that is typically available. |
|||
|
|||
|
MourningWood
Gold Member
Joined: June-13-2014 Location: NorCal Status: Offline Points: 917 |
Post Options
Thanks(0)
Quote Reply
Posted: June-05-2018 at 12:59pm |
||
^Geez Louise! The "box" or the large storage-killer is not necessary. It is/was a simple way to encase the vent and control tubes, as well as provide a footrest. There are several other ways to do this without eating up half the under-bow area. Be imaginative. |
|||
|
1964 Dunphy X-55 "One 'N Dun"
'I measured twice, cut three times, and it's still too short!" |
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: June-01-2018 at 5:43pm |
||
I'll try and track it down in this maze on my PC Thanks |
|||
|
|||
|
shierh
Gold Member
Joined: April-29-2015 Location: Florida Status: Offline Points: 605 |
Post Options
Thanks(0)
Quote Reply
Posted: June-01-2018 at 5:10pm |
||
|
my set up is a bit easier, i think i sent it to you a while back.
|
|||
|
|||
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 9:59pm |
||
Necessary or not, the "air box" provided a means of terminating/holding the ventilation hose, conduit for the wiring/cables, a support for the kick and then a spot for extra flotation foam. |
|||
|
|||
|
Watauga
Senior Member
Joined: June-12-2009 Location: United States Status: Offline Points: 208 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 9:14pm |
||
|
|||
|
|||
|
Watauga
Senior Member
Joined: June-12-2009 Location: United States Status: Offline Points: 208 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 9:08pm |
||
|
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 7:41pm |
||
Is it needed? Do I have to? Does the boat need it? |
|||
|
|||
|
Hollywood
Moderator Group
Joined: February-04-2004 Location: Twin Lakes, WI Status: Offline Points: 13515 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 7:19pm |
||
|
Define necessary.
|
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 7:05pm |
||
|
Thanks.
Have another question. Is it necessary to put that big airbox back in the floor? |
|||
|
|||
|
MechGaT
Senior Member
Joined: March-09-2015 Location: Chattanooga Status: Offline Points: 271 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 4:25pm |
||
|
Look on the first page of this thread , it has some pictures.
|
|||
|
'92 Sport Nautique
|
|||
|
|||
|
jterr
Gold Member
Joined: February-13-2018 Location: N. Florida Status: Offline Points: 621 |
Post Options
Thanks(0)
Quote Reply
Posted: May-28-2018 at 2:52pm |
||
|
Need pics(I saw somewhere) of the PVC setup/replacement pipes up front of boat for venting and cables'
Thanks JT |
|||
|
|||
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
8122pbrainard wrote: