fiberglass floor pan |
Post Reply |
Author | |
93/70 ccpb
Senior Member Joined: March-05-2006 Location: United States Status: Offline Points: 448 |
Post Options
Thanks(0)
Posted: April-08-2019 at 10:31pm |
ill try to get out of boat shed and get some accurate measurments, alot more parts on facebook correct craft,couldnt get to load here,freeing up parts for funds for my 65 barracuda project,
|
|
what you dont want to hear from jbear and bill.you cant get in the boat till you get your minute,and they throw you back in water!
|
|
TRBenj
Grand Poobah Joined: June-29-2005 Location: NWCT Status: Offline Points: 21186 |
Post Options
Thanks(0)
|
Agree 65” sounds way wide for a Mustang. Does the width taper much? If not, it may be for a vee hull. I think I’ve seen a Freeport with the pan. Other than the Mustang, I think it’s the only model that may have gotten them.
Marty, I don’t think anything got them prior to ‘67. Guessing your Skylark had vinyl wrapped ply originally. |
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
Dan,
I've noticed you have been posting a lot in the for sale section. Are you cleaning out the garage? |
|
MartyMabe
Grand Poobah Joined: February-21-2006 Location: High Point,NC Status: Offline Points: 3980 |
Post Options
Thanks(0)
|
Oh Crap! Then too big for the 66 Skylark too!
|
|
93/70 ccpb
Senior Member Joined: March-05-2006 Location: United States Status: Offline Points: 448 |
Post Options
Thanks(0)
|
mid 60 to 70 fiberglass floor pan,65 across by middle of motorbox approx12 foot long,not sure what it came out of.barracuda,wildcat maurarder,ithing it is to big for mustang.330-524-6983 thanks dan
|
|
what you dont want to hear from jbear and bill.you cant get in the boat till you get your minute,and they throw you back in water!
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |