Boats For Sale:
94 Sport PCM 5.8 HO Carbed hard starting when warm |
Post Reply 
|
| Author | |
Jpeck 
Newbie 
Joined: June-12-2020 Location: Gettysburg Status: Offline Points: 4 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 94 Sport PCM 5.8 HO Carbed hard starting when warmPosted: July-07-2020 at 1:05am |
|
Sounds good thanks for the help!
|
|
 |
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 8:47pm |
|
Joe,
You're dripping gas into the engine causing a flooding condition. The WOT is overcoming the gas by allowing more air into the engine. Yes, a carb rebuild should solve it. |
|
|
|
|
Jpeck
Newbie
Joined: June-12-2020 Location: Gettysburg Status: Offline Points: 4 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 8:06pm |
|
Thanks for the input! I can get it restarted, and I do so by pulling the transmission control and putting it wot and it kicks back to life, then put it back to neutral. Is this something I can fix via carb rebuild??
|
|
|
|
|
GottaSki
Grand Poobah
Joined: April-21-2005 Location: NE CT Status: Offline Points: 3363 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 3:02pm |
|
Indeed, as been said
Are you just cranking at idle forever or doing something with the throttle? Joe i see you are 20. thats great. we grew up eating carbs for breakfast, its all we had., but might be foreign to you. Next time it happens, pull the pin and hold it to the boards wide open (reverse is more effective with an MV2 helm) , hit the start then pull the throttle back to neutral as soon as it fires. If this clears it up quick and gets you on the way, then its just loading up with fuel after shutdown with some heat creep into the carb and line, exacerbating a leaky needle/seat ., and less about electronic ignition components . If it still wont fart, one can focus with more clarity on the ignition components |
|
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
|
|
|
TRBenj
Grand Poobah
Joined: June-29-2005 Location: NWCT Status: Offline Points: 21186 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 2:37pm |
|
I would be looking at all possible causes (including a drippy carb). Not to say that Protec can’t be suspect but it would be a bummer if a $500+ retrofit didn’t solve your issue.
|
|
|
|
|
Jonny Quest
Grand Poobah
Joined: August-20-2013 Location: Utah--via Texas Status: Offline Points: 2979 |
Post Options
Thanks(0)
Quote Reply
Posted: July-06-2020 at 1:57pm |
|
My old 1994 the similar symptoms. Hard starting when warm. That eventually worsened to intermittent hard starting regardless of conditions. Then, ProTec suddenly failed altogether. No warning, it simply shut down in the middle of a ski run. That earned me a tow back to the marina....20+ miles away.
ProTec parts are NLA so you may want to do some reading on this site regarding retrofitting back to a distributor and removing ProTec. Many look at ProTec as “not if, but when” it will fail. Good system when it’s working, but..... JQ |
|
|
Current
2003 Ski Nautique 206 Limited Previous 2001 Ski Nautique Open Bow 1994 Ski Nautique Open Bow Aqua skiing, ergo sum |
|
|
|
|
Jpeck
Newbie
Joined: June-12-2020 Location: Gettysburg Status: Offline Points: 4 |
Post Options
Thanks(0)
Quote Reply
Posted: July-05-2020 at 11:26pm |
|
I have a 94 Sport with the PCM 5.8HO with the protech ignition. My issue is that I will be out riding and my engine will warm up and if I turn it off and wait more than 20 min it has a hard time starting. I have no issues if I momentarily turn it off to pick up a skier in the water and turn it back on. it's just when I'm sitting with it for extended periods of time w/o the engine running. I thought it may be either a badly tuned carb or my ignition system is going bad. Any thoughts???
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options