Boats For Sale:
New damper plate doesn’t fit flywheel Alto da106 |
Post Reply 
|
| Author | |
Gary S 
Grand Poobah 
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: New damper plate doesn’t fit flywheel Alto da106Posted: September-08-2020 at 7:55pm |
|
I just bought one fit perfect on an engine that had a PCM trans in it's past life. As an added bonus I ordered and paid for a 106- was going to trim it myself. Received an already trimmed one. Should have bought 2
|
|
 |
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 11112 |
Post Options
Thanks(0)
Quote Reply
Posted: September-08-2020 at 7:36pm |
|
You could call Joe at FFM and discuss it too.
He's the new owner Rumor has it that he did all the real work anyways, while Eric spent his days posting on CCF  Here's a link to his contact info |
|
|
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 11112 |
Post Options
Thanks(0)
Quote Reply
Posted: September-08-2020 at 7:23pm |
|
Other people with the same problem have used washers as spacers.
Here's an old thread in the link below, that discusses washers. It was for a damper plate for a PCM transmission but the idea is still the same Eric in that thread ran a transmission rebuild shop Fantastic Finishes Marine in Ohio. No fair grinding on anything |
|
|
|
|
Lightfoot
Newbie 
Joined: May-04-2009 Status: Offline Points: 12 |
Post Options
Thanks(0)
Quote Reply
Posted: September-08-2020 at 6:28pm |
|
I’ve got an ‘87 ski Nautique with a 351w. I’ve pulled the transmission for repair and bought a new damper plate to put in while I am at it. I bought an alto da-106a from ebasicpower. When attempting to bolt the damper to the flywheel, the damper will not sit flat because the rivets holding the center section of the damper together make a circle slightly larger than the circular recess in the center of my flywheel. (Roughly 1/10th” larger)
Has anyone else run into this issue? Can I put spacers behind the damper plate? Or should I grind the flywheel a bit? I don’t want to throw anything off balance. Thanks John |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options