Boats For Sale:
PCM Apex 5.7 - cap & rotor replacement / no spark |
Post Reply 
|
| Author | |
cgerdz 
Newbie 
Joined: July-01-2019 Location: IL Status: Offline Points: 23 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: PCM Apex 5.7 - cap & rotor replacement / no sparkPosted: April-05-2021 at 9:59pm |
|
To close out the thread, this is the fix and the boat is running well on the hose.
|
|
 |
|
|
cgerdz
Newbie
Joined: July-01-2019 Location: IL Status: Offline Points: 23 |
Post Options
Thanks(0)
Quote Reply
Posted: April-05-2021 at 3:30pm |
|
Decided to order a new distributor after cleaning up the distributor shaft with a wire brush had no impact on no-start/spark condition.
I believe i have the correct procedure to replace the distributor and set the timing below, but if anyone can point out anything i missed, it would be much appreciated. -Get #1 to TDC with rotor pointing at #1 post on distributor -Mark orientation of distributor body and orientation of rotor -Loosen retention bolt on distributor and remove distributor -Insert new distributor with body and rotor orientation matching previous marks -Intall cap -Start engine -Insert jumper wire/paperclip between A & B terminals on 10 pin diagnostic plug -Clip timing light wire to #1 plug wire with arrow towards plug -Set advance dial on timing light to 10 -Rotate distributor to get timing mark to line up with notch on the block -Tighten distributor retaining bolt -Remove jumper wire/paperclip -Go skiing Thanks, Connor
|
|
|
|
|
cgerdz
Newbie
Joined: July-01-2019 Location: IL Status: Offline Points: 23 |
Post Options
Thanks(0)
Quote Reply
Posted: March-31-2021 at 7:20pm |
|
Ran into a bit of a problem getting the rotor off and dented the copper ring underneath it slightly. No start when everything is put back together.
Any advice on best place to start from here? Have a digital multi-meter, just need some guidance on where to check.  |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options