Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Bilge pump
  FAQ FAQ  Forum Search   Register Register  Login Login

Bilge pump

 Post Reply Post Reply   
Author
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Topic: Bilge pump
    Posted: April-10-2021 at 1:27pm
Trey,
I have a feeling you may need a new pump. It's drawing the amps over what it should and triping the breaker. It runs when connected directly to the battery because there isn't a breaker to trip. The only other problem may be a bad breaker but I suspect the pump to be the problem. You could check amp draw with a VOM ( volt Ohm mete) with a 20 amp setting. 


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
Kat Daddy View Drop Down
Newbie
Newbie
Avatar

Joined: June-19-2018
Location: Columbiana, Al
Status: Offline
Points: 35
Post Options Post Options   Thanks (0) Thanks(0)   Quote Kat Daddy Quote  Post ReplyReply Direct Link To This Post Posted: April-10-2021 at 1:17pm
My bilge pump has stopped working due to a possible short in a wire. Pump does work when wired straight to the battery. When the bilge switch is turned on, the ignition light dims and then the circuit breakers pops. Is there a known wiring diagram so i can trace wiring and see what may be wrong? Has anyone else had this issue?
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2025 | Bagley Productions, LLC