Boats For Sale:
Finishing Stringers??? |
Post Reply 
|
| Author | |
SkiBum 
Gold Member 
Joined: November-17-2006 Location: United States Status: Offline Points: 587 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Finishing Stringers???Posted: June-27-2007 at 2:36am |
|
I used Bilgecote enamel over epoxy. Just had to be sure to wash with clean water and a scratch pad before applying the enamel. I also used a primer. It can be brushed on with a nice result. This brand or type of bilge paint is resistant to fuel, oil, and other bad things that tend to end up in the bilge. Makes keeping things clean a little easier.
|
|
 |
|
|
jon4pres
Senior Member 
Joined: September-19-2005 Location: United States Status: Offline Points: 275 |
Post Options
Thanks(0)
Quote Reply
Posted: June-26-2007 at 1:54pm |
|
Thanks for the help guys. I will probably just do bilge paint. I dont have the rescources to spray gel.
|
|
|
|
|
8122pbrainard
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2007 at 9:10pm |
|
Jon4, Tim is correct that the epoxy resin will turn whitish in time when exposed to UV. I wouldn't use a gel coat as I think it's a little overkill plus polyester will not stick to epoxy without a polyvinyl conversion primer. Tinted epoxy would be my first choice but people have had good luck with bilge paint too.
|
|
|
|
|
TRBenj
Grand Poobah
Joined: June-29-2005 Location: NWCT Status: Offline Points: 21192 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2007 at 3:43pm |
|
You dont need to paint them unless youre not covering them up with the floor
Epoxy resin is susceptible to UV light, but thats not a concern for the glass on the stringers that are buried. Not a bad idea to coat the bilge though- gelcoat or bilge paint should do the trick. |
|
|
|
|
jon4pres
Senior Member
Joined: September-19-2005 Location: United States Status: Offline Points: 275 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2007 at 2:58pm |
|
I have all of the fiberglass work done on my stringers and I need to know if I need to paint the exposed fiberglass and if I do what should I use?
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options