Boats For Sale:
Neutral Switch |
Post Reply 
|
| Author | |
David F 
Platinum Member 
Joined: June-11-2004 Location: United States Status: Offline Points: 1770 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Neutral SwitchPosted: August-26-2004 at 5:51pm |
|
The switch simply screws out/in. It has a steel ball that must fit in a notch for the engine to start. So position of the shift lever is critical. Usually, having to wiggle the throttle is more an indication of a worn throttle mechanism than a bad switch. But, if you say it is the switch, then replacement is a 5 minute operation. Polarity of the wires is unimportant.
FWIW: My boat does the same thing and replacing the switch changed nothing. Every once in a while, I have to wiggle the throttle lever to get the boat to start. |
|
 |
|
|
jameski
Senior Member 
Joined: May-18-2004 Location: United States Status: Offline Points: 368 |
Post Options
Thanks(0)
Quote Reply
Posted: August-26-2004 at 10:37am |
|
Thanks for the input. I have verified it IS the switch, and I HAVE bypassed it temporarily. My linkage is adjusted to line up perfectly in neutral, so I guess I need a new switch. Has anyone ever replaced one? Will I need a new flange gasket or does the switch unscrew out of the flange?
|
|
|
|
|
66polyhead
Senior Member
Joined: December-20-2003 Location: United States Status: Offline Points: 171 |
Post Options
Thanks(0)
Quote Reply
Posted: August-26-2004 at 1:51am |
|
I agree with mrese it may not be the switch. Test and see. Could be electrical gremlims
|
|
|
|
|
Barr-acuda
Newbie 
Joined: July-12-2004 Location: United States Status: Offline Points: 15 |
Post Options
Thanks(0)
Quote Reply
Posted: August-25-2004 at 9:59pm |
|
You may want to try pushing the linkage on the transmission towards the rear of the boat. I know of 2 other boats where the cable just doesn't seem to push the lever far enough back to allow the boat to start. At least it doesn't cost anything to try this first. Good Luck
|
|
|
99 SNOB
69 Barracuda |
|
|
|
|
mrese
Groupie 
Joined: February-18-2004 Location: Al Status: Offline Points: 93 |
Post Options
Thanks(0)
Quote Reply
Posted: August-25-2004 at 7:22pm |
|
You can verify it is the neutral safety switch but disconnecting the two wires from the switch and connecting them straight to each other. If your problem goes away, a new switch runs about $20. If you do remove the switch and opt to bypass it while you wait for the new one, do not attempt to start the boat while it is in line and close proximity to something you don't want to hit. Sooner or later you will forget and hit the starter with the boat in gear.
"There are those of us to whom it has happened and those whom it is going to happen" |
|
|
|
|
jameski
Senior Member
Joined: May-18-2004 Location: United States Status: Offline Points: 368 |
Post Options
Thanks(0)
Quote Reply
Posted: August-25-2004 at 1:08pm |
|
I have started having trouble with my Neutral Safety Switch. Sometimes I have to rock the controler back-and-forth to get it to start. Is there any adjustment in the switch, or do I just need to replace it?
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options