Boats For Sale:
Adhesive |
Post Reply 
|
| Author | |
JoeinNY 
Grand Poobah 
Joined: October-19-2005 Location: United States Status: Offline Points: 5698 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: AdhesivePosted: March-18-2008 at 12:48pm |
|
Hows it going Jim, I would look for 3M Headliner Adhesive, it used to be available in autoparts stores I haven't looked in a while but its used to hold foam headliners onto car roofs which become quite hot in the sun. I might also get the edges with a hot melt gun.
-Joe. |
|
 |
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: March-18-2008 at 10:43am |
Solvent based contact cement- No. As mentioned, I'm afraid the solvent will eat the foam. Water base contact cement- Yes. |
|
|
|
|
jhatem
Newbie 
Joined: June-09-2006 Location: United States Status: Offline Points: 15 |
Post Options
Thanks(0)
Quote Reply
Posted: March-18-2008 at 10:28am |
|
It's half off, half on, so I am going to try to re-attach it. How about contact cement?
|
|
|
'97 196
|
|
|
|
|
jhatem
Newbie
Joined: June-09-2006 Location: United States Status: Offline Points: 15 |
Post Options
Thanks(0)
Quote Reply
Posted: March-18-2008 at 10:27am |
|
It's half off, half on, so I am going to try to re-attach it. How about contact cement?
|
|
|
'97 196
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: March-16-2008 at 3:58pm |
|
Jim, I would just leave the foam off but if you want to glue it back, use one of the adhesives in the cartridge designed for foam insulation board. It has a low solvent content so it won't eat the foam.
|
|
|
|
|
winniskier
Senior Member 
Joined: March-15-2008 Location: Gilford, NH Status: Offline Points: 193 |
Post Options
Thanks(0)
Quote Reply
Posted: March-15-2008 at 11:55pm |
|
The foam on the bottom side of the floor panel behind the motor box is coming off of the section that sits directly over the exhaust and muffler. I am assuming that heat is the cause. Any suggestions as to which adhesive to use to stick it back on? Thanks you.
|
|
|
Jim
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
jhatem wrote: