tranny fluid/pressure |
Post Reply |
Author | |
phospher
Gold Member Joined: July-19-2007 Location: United States Status: Offline Points: 557 |
Post Options
Thanks(0)
Posted: May-06-2008 at 6:36pm |
Eric and crew,
This is the type of tranny fluid i'm running in my 1:1 velvet drive. http://www.castrol.com/castrol/sectiongenericarticle.do?categoryId=82915486&contentId=7027043 are you ok with that?? Also, once I've been running for a while and shutdown and check tranny oil level there is always a bit of pressure built up when I pull the dipstick out. Is this normal? I have a small leak in the shift linkage too, what gaskets will i need to replace this seal? The transmission was rebuilt 5 years ago. Thanks |
|
eric lavine
Grand Poobah Joined: August-13-2006 Location: United States Status: Offline Points: 13413 |
Post Options
Thanks(0)
|
I couldnt pull up the page, as long as it says that it is the equivalant of Dexron Mercon.
the pressure is normal in the case, if you notice the spring loaded breather on top, it was designed to pop of at 10 psi. old units have a normal breather to ambient pressure. the gaskets you will need are the triangle gasket for the nuetral safety switch cover and an o-ring that goes around the spool near the lever. these come in the seal and gasket kit or you can get them seperately. those 2 parts are .45 each at DIM, I'll see if i have some spares so you dont have to run your card for .90 call me tommorow Eric |
|
"the things you own will start to own you"
|
|
8122pbrainard
Grand Poobah Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
|
eric lavine
Grand Poobah Joined: August-13-2006 Location: United States Status: Offline Points: 13413 |
Post Options
Thanks(0)
|
Phil, Pete, read the links and keep running it with the fluid,
they have a ask the expert forum if your interested, i asked a few questions |
|
"the things you own will start to own you"
|
|
phospher
Gold Member Joined: July-19-2007 Location: United States Status: Offline Points: 557 |
Post Options
Thanks(0)
|
Eric,
i received the gaskets in the mail today. i changed them out, took the boat out and everything looks good. thanks!! -phil |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |