206 Rear Floorboard Removal

Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic

   Can anyone advise how to lift the center floorboard behind the motor clam shell on my 206. 

From the round inspection cover between the motor and rear seat I saw (using a mirror) that the filter is attached to the stringer but there is no way I can reach it to replace it.

I figure I'd have to remove the rear seat, the seat base, but what else?

Surely the factory could have place the filter in a more accessible location?

Appreciate any advice.

Author	Message Topic Search Topic Options Post Reply Create New Topic Printable Version Translate Topic
Fatboy206 Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: August-26-2008 Location: Dubai Status: Offline Points: 57	Post Options Post Reply Quote Fatboy206 Report Post Thanks(0) Quote Reply Topic: 206 Rear Floorboard Removal Posted: June-23-2009 at 2:35am
	Can anyone advise how to lift the center floorboard behind the motor clam shell on my 206. From the round inspection cover between the motor and rear seat I saw (using a mirror) that the filter is attached to the stringer but there is no way I can reach it to replace it. I figure I'd have to remove the rear seat, the seat base, but what else? Surely the factory could have place the filter in a more accessible location? Appreciate any advice.

kapla Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: March-27-2008 Location: BA, Argentina Status: Offline Points: 6148	Post Options Post Reply Quote kapla Report Post Thanks(0) Quote Reply Posted: June-23-2009 at 2:42am
	don't know what year is your 206 but my 1992 to remove the center fllorboard you need to remove the rear seat and the moterbox..then lift the floor and voila, it lays on the stringer no screwa or anything...what filter are you talking about?
	<a href="">1992 ski nautique

Fatboy206 Members Profile Send Private Message Find Members Posts Add to Buddy List Groupie Joined: August-26-2008 Location: Dubai Status: Offline Points: 57	Post Options Post Reply Quote Fatboy206 Report Post Thanks(0) Quote Reply Posted: June-23-2009 at 4:30am
	kapla, It's a 2008. I was referring to the primary fuel filter canister. I'll have a go at it this weekend. Thank you, appreciate your input.

quinner Members Profile Send Private Message Find Members Posts Add to Buddy List Grand Poobah Joined: October-12-2005 Location: Unknown Status: Offline Points: 5828	Post Options Post Reply Quote quinner Report Post Thanks(0) Quote Reply Posted: June-23-2009 at 10:25am
	Sebastian is correct, the 206 removes the same way. Pull the 2 pins from the motorbox hinges to remove box, remove rear seat pad and base, should be 2 rubber straps on each piece, once all that is out of the boat the floor board should come out, no screws. What filter is back there? Are you sure you are not looking at one of the ballast pumps? If you have an Excalibur there should be a fuel/water separator filter in the FCC towards the front of the motor and your strainer for the water intake should be at the rear of the motor after the water pickup. That's how my 05' is set up if CC has not changed anything.
	Mi Bowt

206 Rear Floorboard Removal

About CCF

Donate

Partners

Contact