Need the do-hickey thingy

Throttle linkage???

BKH

No the other thingy, the clamp thing that clamps in the groove of the cable like the one on the tranny cable.
And I think that O-ring fits the newer strainers like pictured above it on that site.
Thanks for trying though much appreciated

Any hydrolic shop well have the o ring take your strainer down to the shop and they will match it up.I took some o rings down to get matched up. It took the guy 2 min. I asked what i owed him, he told me to come back when I needed something !

Paul,
I too would hate to buy the complete kit just for something that's very similar to a two hole pipe strap. I'd be cruising around a well equipped hardware store. I know the normal two hole pipe straps don't go that small but the Vibration dampening ones with the nylon inserts do. They go down to 1/4" OD tube size. If you can't find anything that may work, start bending and drilling. Instead of the dimple in the middle that fits into the annular grove in the cable barrel, I'd drill and tap for a small 6-32 set screw.

I can't believe it, nobody has an extra Do-hickey-thingy!!!!!

Thanks Marty,
You be da man!!

Well there you go, I was asking for the wrong thingy.

Thanks all

MartyMabe wrote: go2marinethingy But I like Steve's(62wood) prices better

I ordered two of them . I think shipping was only a buck or so for them both!