Cleaning fuel tank

Managed, but holy cr@p getting that hose off... took me a good hour. Hadn't been off there since '85 I'm sure. Loads of dirt came out, hope to get a pic today when I fill it up again and see how it runs.
Couldn't find the same hose but found something at a car mechanics that at least fitted (this is what was left over after I used the straight part):
Just a water hose I think. Should I expect trouble with this? Planning to get the right hose whenever I place my next order at skidim.

This piece of metal (aluminum?) came out of the tank. Any idea what it is?


Thanks for your advice everybody!

It is pretty easy. You will need to get the gas fill hose off of the metal gas inlet. your rubber hose may be welded to the inlet, depending on how old it is. Disconnect the wiring for your gas gauge on top of the tank. There are four bolts (2 on each end) that hold the tank in place. You should try and get as much of the gas out as possible before you start to make the tank lighter.

What do I have to change in my links to make them work?

I assume it's a metal tank. How bad is it? Just cleaning out gunk or rust or both? Is the whole inside nasty or just the bottom where everything collects?

When my tank sat idle for three years during my rides decommissioning, there was about a half inch of fuel left in it that I couldn't siphon out. When I was ready to get it running, there was some nasty, thick syrup consistency gunk in the bottom of the tank. No rust anywhere thankfully.
I called several radiator shops who wouldn't touch it anymore with the EPA regs in place now. I also called several speed shops and did some internet searches.
There were some inconsistencies in what type cleaner to use but virtually everybody agreed to pour a gallon or two of some type of cleaner (mineral spirits, acetone, kerosene, etc.) in the tank and throw a couple of handfulls of nuts and bolts in with it. Several guys said to pour a couple of boxes of BB's (for a BB gun)in it. Shake it around, let it sit and shake it around some more. The nuts and bolts or BB's rolling around with the cleaner in the tank will loosen up any rust that might be in there.
I used a gallon of mineral spirits after the tank was removed and sitting on a level surface. I lifted one end a couple of feet and set it down, then lifted up the other end and set it down. Repeat a dozen times and let it sit.
I did the same thing twice a day for a week and then emptied it out. It was absolutely crystal clear after I was done. I didn't use the nuts and bolts as I didn't have any rust but was assured by several different sources that it works. It was a little laborious on my part and certainly time consuming but everything turned out perfect and all it cost me was a few dollars for a gallon of mineral spirits.

I believe someone in here has an Oliver brand fuel tank cleaning machine, and I think there's even a helpful video.

Any tips and tricks for pulling out and cleaning the fuel tank ('85 2001)?
Cleaning I guess is keeping it upside down (after draining) until all the dirt is out of there and then rinse a couple times with gasoline?

Thanks!