Boats For Sale:
Intake Manifold air? |
Post Reply 
|
| Author | |
osg_ryan 
Newbie 
Joined: October-16-2006 Location: United States Status: Offline Points: 6 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Intake Manifold air?Posted: October-16-2006 at 4:52pm |
|
Just finished rebuilding the motor on my 92 ski natique 351W, and after putting the intake maniford back on the long block, when I crank the engine over and stop, there seems to be air comming from the two bolts that hold the throttle cable. Not sure if this is suppose to happen or not any answers?
|
|
 |
|
|
Hollywood
Moderator Group 
Joined: February-04-2004 Location: Twin Lakes, WI Status: Offline Points: 13515 |
Post Options
Thanks(0)
Quote Reply
Posted: October-16-2006 at 4:55pm |
|
I'm no expert but that sounds bad to me.
|
|
|
|
|
JoeinNY
Grand Poobah 
Joined: October-19-2005 Location: United States Status: Offline Points: 5698 |
Post Options
Thanks(0)
Quote Reply
Posted: October-16-2006 at 5:28pm |
|
Not supposed to happen, you have a leak in the exhaust crossover portion of the intake manifold gaskets most likely. Did you use new gaskets? Were both surfaces (head and intake) flat and smooth, did you slap on some gasinich or the equilvent gasket glue. Proper torque proceedure followed? One or more has gone arwy order some new gaskets and pull it off, sorry.
|
|
|
|
|
osg_ryan
Newbie
Joined: October-16-2006 Location: United States Status: Offline Points: 6 |
Post Options
Thanks(0)
Quote Reply
Posted: October-16-2006 at 5:39pm |
|
Both surfaces were clean (new Heads and gaskets and gasket glue and proper torque pattern). I called my motor shop that did the moror and asked them about the problem they said it might be a bad seal or warped manifold. Thanks
|
|
|
|
|
osg_ryan
Newbie
Joined: October-16-2006 Location: United States Status: Offline Points: 6 |
Post Options
Thanks(0)
Quote Reply
Posted: October-17-2006 at 11:00pm |
|
I think I found the problem. When I replaced the Starter they gave me the wrong one. I compared the bevel on the starter gear and the two are different, so I think I was starting the motor backwards.
|
|
|
|
|
JoeinNY
Grand Poobah
Joined: October-19-2005 Location: United States Status: Offline Points: 5698 |
Post Options
Thanks(0)
Quote Reply
Posted: October-18-2006 at 8:14am |
|
Once you get her running in the right direction give it a check for vacuum leaks. Hopefully the hissing you heard was actually from the carb area and you are all good now.
Joe. |
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options