Bank 1 EFI Problem |
Post Reply |
Author | |
the bull
Newbie Joined: June-08-2014 Location: NC Status: Offline Points: 9 |
Post Options
Thanks(0)
Posted: July-19-2014 at 4:03pm |
1995 PCM 5.8 GT40 EFI
I have a problem with bank 1 not sending a signal to the injectors to pulse. The wire for bank one is good all the way to the ECM connector. Anyone seen this? Cheers Tommy |
|
the bull
Newbie Joined: June-08-2014 Location: NC Status: Offline Points: 9 |
Post Options
Thanks(0)
|
Okay here is what I found......
I pulled the computer out and all the way apart and inspected it. The caps were good and all the solder joints looked perfect. There was some corrosion on the part of the board (looks like a test port where the plastic cover is on the case) that was not covered in the clear rubber stuff that they spray on the board to protect it. I cleaned that off with brake cleaner and covered the area with dielectric grease. She fires up and purrs like a lion now. Wonder if the corrosion was making a path for electricity to go to another terminal. Hope this fixes it!!!!! |
|
Bri892001
Grand Poobah Joined: September-27-2008 Location: Boston MA Status: Offline Points: 4947 |
Post Options
Thanks(0)
|
That's cool man. When I get back to my PC I'll document this one on the GT40 thread.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |