carpet install

Well

after almost 2 years of having the skins stored at home, I decided to go ahead and have them installed.
I will be replacing some of the foams in the worned seat cushions, and also replacing the carpet.
I bought a 12 yard long x 8 ft wide carpet roll, it is supposed to be enough I hope for the whole boat.
Now my question is how Im I supposed to lay it to make full profit of it?
Tomorrow I´m taking pictures to show the before and after!!
now the interior is completely shot!

That might be enough to do two boats if you're really frugal with it! lOl. You know we like pics from Argentina.

Seb,
Mix the acetone or for a slower mix toluene, with the resin and hardener first. Then when you are ready to use it, mix the two epoxy components.

I thougt its the epoxy resin and the herdener they sell.
So it should be a two part epoxy and the hardener?
I will see what I can get at the resin shop!
thanks

C-Bass wrote: I thought Xylene was the solvent of choice for home brew CPES. I've used it before and had good results. Never tried acetone or anything else, so not saying those won't work.

Craig,
Xylene and Toluene are very close with their solvency and evaporation rate. Xylene is just a tad bit slower than the Toluene.

I have the epoxy resin and it hardener, Nad the Toluene.
So to use it I need to mix the toluene with the herdener , and them misx it up with the resin correct.?

We are heving average 50º temperatures here, so this will slow down the curing process, or I need to change the mixing ratios? }o better raise the temperature to the 60º-65º

ttt

I've seen that interior before (when we redid ours). lol.

Is that the new carpet?

no updates lately here, but some progress, will post pictures later.
The guy doing the job is having a hard time removing the old carpet from the floor, Is it possible contact cement to stick more to epoxy resin?
side wall carpet was removed without any issue but the floor carpet is severely difficult to pull out! Toluen is a cement glue remover, but can it affect the cured epoxy resin? I was considering usind the toluene to try to soften the old glue....