FCC plug issue |
Post Reply |
Author | |
wetskier2000
Senior Member Joined: September-07-2005 Location: New Hampshire Status: Offline Points: 367 |
Post Options
Thanks(0)
Posted: June-24-2018 at 10:17pm |
Drained the FCC today. went to put the plug back in, went fine at first, tightened up then felt like it was stripping. Felt around down there to find the bung the brass plug goes into is spinning. I have not pulled the FCC yet, but will... What will I find? Repairable? Anyone know?
|
|
Current: 1997 Nautique
Previous: 1987 Nautique 1964 American Skier |
|
wetskier2000
Senior Member Joined: September-07-2005 Location: New Hampshire Status: Offline Points: 367 |
Post Options
Thanks(0)
|
Turns out that right there in the engine manual it says use a 3/4 wrench to hold what I thought was a bung on the bottom of the FCC while putting the brass plug back in. All is well with that. New filter installed.
Unfortunately, the cutting out continues... Once the engine has been driven a bit and fairly warm, it will cut out completely while underway. Has happened at both kneeboard and slalom speeds. Then while we still have good momentum, it will start back up. Any ideas? |
|
Current: 1997 Nautique
Previous: 1987 Nautique 1964 American Skier |
|
JoeinNY
Grand Poobah Joined: October-19-2005 Location: United States Status: Offline Points: 5698 |
Post Options
Thanks(0)
|
More info on what the engine is would be helpful but if I am guessing blind its a low pressure fuel pump on its way out. |
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |