Boats For Sale:
1990 351 Ford |
Post Reply 
|
| Author | |
tarpon32 
Newbie 
Joined: April-11-2019 Location: Alabama Status: Offline Points: 37 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: 1990 351 FordPosted: July-10-2023 at 12:56pm |
|
Extended running 25-35minutes at 2500 rpm wiil cause the engine to lose power and stall' acts like running out of fuel. New fuel pump and changed the filter to spin on. Fuel vent seems to work ok, refueling the boat comes out when full. When it stalls, a few seconds at lower rpm runs fine. A suggestion was to run the boat with the fuel cap open, to check the vent. 2000-2100 rpm it runs all day. Original holly carb, have not checked the float level. No back fire or miss , does not act like ignition runs too good at lower rpm. Any help Randy
|
|
|
Randy
|
|
 |
|
|
KENO
Grand Poobah 
Joined: June-06-2004 Location: United States Status: Offline Points: 11112 |
Post Options
Thanks(0)
Quote Reply
Posted: July-12-2023 at 7:12am |
I'd check the ignition system  Old Chinese proverb................90 % of all carburetor problems are ignition related. (Especially if you think it's not the ignition) What's it got for an ignition system
|
|
|
|
|
tarpon32
Newbie
Joined: April-11-2019 Location: Alabama Status: Offline Points: 37 |
Post Options
Thanks(0)
Quote Reply
Posted: July-13-2023 at 8:04am |
|
Original ignition system. does not miss except long running over 2500 RPM, then reduce throttle for a second then go again. Like time for the carb to refill. Randy
|
|
|
Randy
|
|
|
|
|
KENO
Grand Poobah
Joined: June-06-2004 Location: United States Status: Offline Points: 11112 |
Post Options
Thanks(0)
Quote Reply
Posted: July-13-2023 at 10:58am |
|
So you probably have points unless there was an electronic conversion sometime in the past.
I'd listen to the Chinese guy (he's whispering in my ear............tell him to replace his coil (strictly for troubleshooting of course), it's pretty cheap Your first and second posts sound somewhat different, does it quit (post #1) or as it's acting up you reduce speed and things recover (post #2) ? But, since you're zeroed in on fuel as a problem, hook a temporary tank to the suction of the fuel pump. Make sure the tank is vented and run the boat that way to see if the problem is still there That'll give you some info
|
|
|
|
|
GottaSki
Grand Poobah
Joined: April-21-2005 Location: NE CT Status: Offline Points: 3363 |
Post Options
Thanks(0)
Quote Reply
Posted: July-13-2023 at 11:40am |
|
|
|
"There is nothing, absolutely nothing, half so much worthwhile as messing around with boats...simply messing."
River Rat to Mole |
|
|
|
|
tarpon32
Newbie
Joined: April-11-2019 Location: Alabama Status: Offline Points: 37 |
Post Options
Thanks(0)
Quote Reply
Posted: July-31-2023 at 4:19pm |
|
Still trobleshooting , is there an anti-siphon valve in the gas tank line? I had a similar problem in an outboard, Randy
|
|
|
Randy
|
|
|
|
|
Faceplant
Senior Member 
Joined: July-27-2013 Location: Otter Lake , Mi Status: Offline Points: 417 |
Post Options
Thanks(0)
Quote Reply
Posted: August-03-2023 at 9:24pm |
|
Yes. On my 1988 , it is in the line right on top of the tank .
|
|
|
Feels like I am hanging 10 but in reality - probably hanging 6.
|
|
|
|
|
tarpon32
Newbie
Joined: April-11-2019 Location: Alabama Status: Offline Points: 37 |
Post Options
Thanks(0)
Quote Reply
Posted: August-14-2023 at 9:07am |
|
Ran a load of gas yesterday with no problem. Replaced the anti sihpon valve in the tank feed line. I could not easily push the ball in the 33 year old valve like the new one. Takes 2 to lift the rear seat, remove the tank clamps, move the tank enough to remove the hose and lift the feed tube out of the tank. Randy
|
|
|
Randy
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
tarpon32 wrote: