Boats For Sale:
water pump |
Post Reply 
|
| Author | |
stang72 
Platinum Member 
Joined: July-31-2004 Location: United States Status: Offline Points: 1608 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: water pumpPosted: August-02-2007 at 3:19pm |
|
When running the boat in the drive on a hose....I am not getting much water out the exhaust...seems as if the RWP is not pulling enough water...I have anew impeller and O ring and it's installed correctly(it was doing this before the new impeller)pump looked good ...checked hoses for to make sure things are tight...flushed strainer(all is good there).
If T stat is bad will this effect the flow out the exhaust??? T stat housing is getting pretty hot after 5 min or so.As is the intake manifold. Does the circ pump effect the flow out? Not sure where to go next? The boat did over heat on the lake....it stays right at 143...but was up to about 170 deg before I popped it on the trailer. |
|
 |
|
|
Tim D
Grand Poobah 
Joined: August-23-2004 Location: United States Status: Offline Points: 2641 |
Post Options
Thanks(0)
Quote Reply
Posted: August-02-2007 at 3:47pm |
|
Are you using a fake-a-lake? Was it sucked up tight with no leaking? If so, you might not had the water flow high enough.
|
|
|
Tim D
|
|
|
|
|
stang72
Platinum Member
Joined: July-31-2004 Location: United States Status: Offline Points: 1608 |
Post Options
Thanks(0)
Quote Reply
Posted: August-02-2007 at 4:08pm |
|
No fake-a-lake ,I use a hose up into the intake hose as far as it will go with no clamping...same as I always do...but much less exiting the exhaust. I turn the hose on enough that there is always water not getting sucked up(some goes back out the intake hose into the bilge. That has always worked in the past on all four boats. I wrapped my hand around the hose where the garden hose enters the intake hose and felt no extra suction.
|
|
|
|
|
8122pbrainard
Grand Poobah
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
Post Options
Thanks(0)
Quote Reply
Posted: August-02-2007 at 4:14pm |
|
Gary, I think you have a leak somewhere on the suction side and are pulling air. The hose should supply plenty of water. The closed T stat will simply by pass the water out the back. The circ pump simply keeps the water moving through the block when the T stat is not fully open.
|
|
|
|
|
stang72
Platinum Member
Joined: July-31-2004 Location: United States Status: Offline Points: 1608 |
Post Options
Thanks(0)
Quote Reply
Posted: August-02-2007 at 4:43pm |
|
Wll check for leaks! Thanks.
|
|
|
|
|
stang72
Platinum Member
Joined: July-31-2004 Location: United States Status: Offline Points: 1608 |
Post Options
Thanks(0)
Quote Reply
Posted: August-02-2007 at 10:29pm |
|
Well tighten all hoses...checked the t stat in hot water..it was fine..put a new gasket in the housing...ran it up to temp...everything seems fine.
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options