1965 289 ford |
Post Reply |
Author | |
ethyl
Groupie Joined: April-04-2008 Location: United States Status: Offline Points: 55 |
Post Options
Thanks(0)
Posted: May-17-2008 at 12:25am |
My '65 Amer. Skier has a 289 Interceptor. I replaced the points, condenser, plugs wires and thought I needed to adjust the valve lash. I did so using several different methods as per this site and Ford sites. When the lash was zero at TDC and when the exhaust valve was coming up/ intake valve almost down plus 1/2 turn methods were used I had no compression when the engine was turned over. It was as if all the spark plugs were removed. So I placed each cylinder at TDC and adjusted to .11" clearance. This gave me compression but the old girl was backfiring so I switched the plug wires 180 with no response. The engine ran at partial throttle before I messed with it but did not want to idle. Before I messed with the valve lash there was considerable lash at TDC. Please help me! Thanks, John.
|
|
Tim D
Grand Poobah Joined: August-23-2004 Location: United States Status: Offline Points: 2641 |
Post Options
Thanks(0)
|
What firing order are you using?
|
|
Tim D
|
|
ethyl
Groupie Joined: April-04-2008 Location: United States Status: Offline Points: 55 |
Post Options
Thanks(0)
|
Tim, good question. After I posted, I went back out to the boat and replaced the plug wires as they were before which gives a firing order of 1275648 and she fired right up and ran well. This is with .11 clearance at TDC. All the books show a firing order of 15426378. I am confused. Do you think this engine may have solid lifters? Thanks, John.
|
|
Tim D
Grand Poobah Joined: August-23-2004 Location: United States Status: Offline Points: 2641 |
Post Options
Thanks(0)
|
It should have solid lifters, unless the cam has been changed.
|
|
Tim D
|
|
64 Skier
Senior Member Joined: February-08-2004 Location: United States Status: Offline Points: 415 |
Post Options
Thanks(0)
|
My 289 is a '65 vintage as well with a solid lifter and cam set-up. Woody at CC instructed me to set valve lash at 20 thousandths after warm-up.
|
|
Post Reply | |
Tweet
|
Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |