Forums
NautiqueParts.comNautiqueSkins.com - Correct Craft Upholstery and Part
  New Posts New Posts RSS Feed - Loose Windshield
  FAQ FAQ  Forum Search   Register Register  Login Login

Loose Windshield

 Post Reply Post Reply   
Author
hughes26 View Drop Down
Newbie
Newbie
Avatar

Joined: July-13-2011
Location: SC
Status: Offline
Points: 34
Post Options Post Options   Thanks (0) Thanks(0)   Quote hughes26 Quote  Post ReplyReply Direct Link To This Post Topic: Loose Windshield
    Posted: May-30-2013 at 11:52am
On my 77 Nautique where the windshield comes together at the middle support is loose. The bolts under the dash that hold the windshield on seem to all be tight. Is there something else that would tighten up the windshield where it comes together in the middle? I don't want to take the windshield off if there is no way to tighten it up.

Thanks.
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: May-30-2013 at 8:05pm
They may "seem" loose but, have you tried tightening them? There's also a thin rubber gasket under the frame. Is it still there?


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
hughes26 View Drop Down
Newbie
Newbie
Avatar

Joined: July-13-2011
Location: SC
Status: Offline
Points: 34
Post Options Post Options   Thanks (0) Thanks(0)   Quote hughes26 Quote  Post ReplyReply Direct Link To This Post Posted: June-03-2013 at 11:50pm
I was not able to check the bolts this weekend. The gasket seems to still be in place. The windshield is tight and firm at the base, it's just at the center top point of the windshield where it's loose.
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: June-04-2013 at 6:23am
The center of the windshield frame is actually a pivot built into the aluminum extrusion. This allows the angle of the two frames to be adjusted slightly so the bottom frame fits the deck exactly. I'd force some black silicone into the joint from both sides near the top. Wipe off the excess and you won't see it's in there.


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC