Boats For Sale:
Walters V Drive oil change question |
Post Reply 
|
| Author | |
8122pbrainard 
Grand Poobah 
Joined: September-14-2006 Location: Three Lakes Wi. Status: Offline Points: 41045 |
 Post Options
 Thanks(0)
 Quote Reply
 Topic: Walters V Drive oil change questionPosted: June-25-2014 at 10:44pm |
|
This sure is another Walters engineering wonder/blunder!! Since they use the U joints instead of bevel gearing, the non detergent oil is needed. A detergent oil would create too much foam.
|
|
 |
|
|
JPASS
Grand Poobah
Joined: June-17-2013 Location: Orlando Status: Offline Points: 2283 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2014 at 9:50pm |
Eat some Wheaties and try again. Lol. It does take a bit of force to yank it out. |
|
|
'92 Correctcraft Ski Nautique
|
|
|
|
|
Gary S
Grand Poobah
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2014 at 9:36pm |
|
Thanks Don. It's stuck good just didn't want to break anything. I think what your seeing with the black oil down in the bottom, is from the use of non detergent oil,all the crud settles to the bottom. I'll let you know how mine looks I have no idea when it was last changed
|
|
|
|
|
TX Foilhead
Grand Poobah
Joined: February-01-2009 Location: Kingsland TX Status: Offline Points: 2076 |
Post Options
Thanks(0)
Quote Reply
Posted: June-25-2014 at 7:54pm |
|
Just an O ring holding it in so it shouldn't be hard to get out. I drained mine completely while the motor was out, there are 2 magnetic plugs below the drain hole, they had some fuzz and black oil when I pulled them. All the oil that came out of the regular drain looked new as it did every time I checked it. I'm not sure if you can reach those without pulling the Vdrive, but if you can those are the plugs I would pull.
|
|
|
|
|
Gary S
Grand Poobah
Joined: November-30-2006 Location: Illinois Status: Offline Points: 14096 |
Post Options
Thanks(0)
Quote Reply
Posted: June-24-2014 at 10:02pm |
|
Went to change oil in it before GL and I can't get the dip stick out. I don't want to break something so close to going. The manual says it just pulls out,so I tried to pry on it a little but no go. Almost looks easier to pull the floor up to work on it too--- any tips?
|
|
|
|
|
Post Reply
|
|
Tweet
|
| Forum Jump | Forum Permissions You cannot post new topics in this forum You cannot reply to topics in this forum You cannot delete your posts in this forum You cannot edit your posts in this forum You cannot create polls in this forum You cannot vote in polls in this forum |
Topic Options
Gary S wrote: