Forums
NautiqueParts.comCalendar Photo Submission
  New Posts New Posts RSS Feed - backfire
  FAQ FAQ  Forum Search   Register Register  Login Login

backfire

 Post Reply Post Reply   
Author
044mcmilt View Drop Down
Newbie
Newbie
Avatar

Joined: April-15-2017
Location: phoenix
Status: Offline
Points: 3
Post Options Post Options   Thanks (0) Thanks(0)   Quote 044mcmilt Quote  Post ReplyReply Direct Link To This Post Topic: backfire
    Posted: April-15-2017 at 1:11pm
recently redid my entire 74 Nautique. 351 windsor changed to marine holley and added pertronics ignition. boat ran fine in drive. went to lake and 3/4 throttle backfired a lot and smoothed out at full throttle. when back home i notice boat has always had distributor 180 off along with wiring 180 off. boat always ran good this way. do you think this coyld be my issue or Carb? i should of done one change at a time but is ran so good in the drive i proceeded to finish whole motor. new fuel pump,wires cap and plugs.... any thoughts?
tom
Back to Top
8122pbrainard View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: September-14-2006
Location: Three Lakes Wi.
Status: Offline
Points: 41045
Post Options Post Options   Thanks (0) Thanks(0)   Quote 8122pbrainard Quote  Post ReplyReply Direct Link To This Post Posted: April-15-2017 at 2:32pm
Tom,
What do you mean by the distributor being 180 off? An engine won't run if the firing order is 180 off. As long as you have the firing order correct referenced from the #1 TDC, you should be fine. Are using the correct firing order? Is the engine the original RR?

What did you do to set the float levels in the carb? Backfiring usually is a lean condition.

Why the Pertronics EI conversion?


54 Atom


77 Tique

64 X55 Dunphy

Keep it original, Pete
<
Back to Top
TRBenj View Drop Down
Grand Poobah
Grand Poobah
Avatar

Joined: June-29-2005
Location: NWCT
Status: Offline
Points: 21171
Post Options Post Options   Thanks (0) Thanks(0)   Quote TRBenj Quote  Post ReplyReply Direct Link To This Post Posted: April-15-2017 at 2:41pm
Don't look at carb, look at timing.
Back to Top
 Post Reply Post Reply
  Share Topic   

Forum Jump Forum Permissions View Drop Down

Copyright 2024 | Bagley Productions, LLC